Eureka 2280 warranty HOW to USE, Cleaner Height Setting

HOW TO USE

The upright vacuum cleaner design allows use on multiple types of carpeting and on upholstery or bare floors with attachments.

When using the attachment tools, place the handle in the upright position. Do not place cleaner on furniture or steps as the brush roll may cause damage.

1.Adjust cleaner height setting knob to lowest position for maximum cleaning. Adjust to a higher setting to make pushing easier. For easy adjustments, tilt the cleaner back to move the setting knob.

2.Unwind all of the electrical cord. The upper cord hook rotates downward to release cord. When storing cord twist back to upright position.

3.Plug electrical cord into outlet.

4.Step on handle release. Pull handle back to a comfortable position.

5.Push On or Off power switch.

Store or

Use Attachments

Use

Clean

Under

Handle

4 Release

Cleaner Height Setting

WARNING: Avoid injury. Keep loose clothing, hair, fingers, and all other parts of body away from any moving part (such as the revolving brush). Turn off the switch and unplug the cleaner before changing the cleaner height setting.

The front of the cleaner has an adjustment that raises or lowers the cleaner base to match the type of carpet. With the cleaner cord unplugged, set the adjustment to lowest setting for maximum cleaning. If the cleaner is difficult to push, move adjustment to next highest setting until cleaner is comfortable to push. The brush roll bristles must reach the carpet for effective cleaning.

NOTE: For ease in moving the adjustment knob, place handle in operating position and tilt cleaner back to remove weight from front wheels.

NOTE: When handle is in upright position, brush roll is lifted off carpet. This is normal. Height adjustment will not change brush roll level until the cleaner’s handle is moved into the operating position.

2

3

5	4 Handle
ON/OFF	Release

HIGH LOW

1

Thermal Cut Off

This cleaner has a special thermostat that protects the cleaner in case of motor overheating. If the cleaner suddenly turns off, follow this procedure:

1.Push on/off pedal once.

2.Unplug cleaner.

3.Check for source of overheating problem (i.e. full bag, clogged hose or clogged filter).

4.If a full bag, clogged hose or clogged filter is found, replace the bag, unclog the hose or replace the filters.

5.Wait at least 30 minutes before attempting to reuse the cleaner.

6.After 30 minute cool down period, plug the cleaner in and push the switch pedal. The cleaner should turn on.

7.If the cleaner still does not operate, take it to any Eureka Authorized Service Center for repair.

7