Bissell 95P1 warranty Checking.rotating floor brush and drive belt, Replace drive belt

Maintenance and care

Checking.rotating floor brush and drive belt continued

5.Clean strings, hair and other debris from rotating floor brush, paying particular attention to brush ends.

6.Clean strings, hair and other debris from motor pulley and drive belt areas.

7.Check drive belt carefully for wear, cuts or stressed areas.

8.Check air passageway for obstruc- tions. Remove debris from this area.

Replace drive belt

Use only genuine BISSELL style 9 replacement belts (#32074) in your BISSELL CleanView Helix.

1.Unplug cleaner from electrical outlet.

2.With rotating floor brush removed from vacuum cleaner (steps 1-4 of Check rotating floor brush and drive belt), grasp old drive belt and remove from motor pulley. Discard old drive belt.

3.Place new drive belt over motor pulley and stretch other end over rotating floor brush in the space between the bristles.

4.Place ends of rotating floor brush down into slots on sides as shown.

5.Turn rotating floor brush by hand several times in the direction of motor pulley. If properly installed, drive belt will center itself on rotating brush.

6.Reposition brush cover and screw back into place.

8.

Air Passageway

4.

Motor

Pulley

11

w w w. b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1