Operations
Power cord storage
When you have finished using your BISSELL CleanView Helix, return it to the upright position and store the power cord.
1.Turn vacuum cleaner off.
2.Unplug power cord by grasping the polarized plug (NOT the cord) and dis- connect from outlet.
3.Loop power cord around cord wraps on side of vacuum cleaner.
4.Clip molded plug to power cord to secure.
NOTICE:
While vacuuming, certain carpets and low humidity conditions may generate small static discharges. The discharges are entirely harmless and are not associated in any way with the main power supply.
Maintenance and care
To maintain maximum cleaning per- formance, the following maintenance steps must be performed:
1.Empty the dirt container when the dirt reaches the “Full” line on the side.
2.Check the inner and outer circular filters and the
3.Replace the post-motor filter every three to six months.
Note: More frequent filter clean- ing or replacing may be necessary if you are vacuuming new carpet, fine dust, or have allergy concerns. Follow the instructions on the fol- lowing pages to perform these simple maintenance steps.
WARNING:
To reduce the risk of electric shock, turn power switch OFF and disconnect polarized plug from electrical outlet before performing maintenance or troubleshooting checks.
Tip:
For maximum cleaning performance, check and clean or replace all filters as suggested.
Empty Dirt Container
The dirt container needs to be emptied |
| ||
when the dirt reaches the “Full” line on |
| ||
the side of the container. | 2. |
| |
1. | Unplug cleaner from electrical outlet. |
| |
|
| ||
2. | Slide the Lock 'n Seal™ lever to the |
|
|
| "Unlock" position. |
|
|
3. | Grasp dirt cup portion handle and pull |
|
|
| straight out to remove from vacuum. | Unlock Position |
|
|
|
4.Empty dirt into garbage container.
Full Line
Lock Position
8 w w w. b i s s e l l . c o m | 8 0 0 . 2 3 7 . 7 6 9 1 |