Cleaning the pre-motor filter

Maintenance and care

1.Unplug the cleaner from electrical outlet.

2.The pre-motor filter protects the motor from debris. It is located underneath the filter cup in the center of the round part of the

Lock ‘n Seal™ lever.

3.Remove the small round filter and any debris on top of it. Rinse well under warm water, then air dry thoroughly before replacing.

Replacing the post-motor filter

Use only genuine BISSELL style 9 (#32076) replacement filters in your BISSELL CleanView Helix.

1.Unplug the cleaner from electrical outlet.

WARNING:

Do not operate cleaner with damp or wet filters or without all filters in place.

Pre-Motor

Filter

2.The post-motor filter assists in the filtration process to return clean air to the room. It is located behind the door on the side of the vacuum. When the filter becomes dirty, open the door, remove the filter and replace. The white, pleated HEPA Media Filter* is

not washable.

Note: A basic washable post-motor filter with reduced filtration is available if desired.

Post-Motor

Filter

WARNING:

To reduce the risk of injury from moving parts, turn off vacuum cleaner and disconnect Power Plug from electrical outlet.

Checking rotating floor brush and drive belt

You should check your vacuum clean- er’s rotating floor brush and drive belt regularly for wear or damage. You should also clean the brush and brush ends of strings, hair and carpet fibers. These can wrap around the brush and hamper its ability to effectively clean your carpet. Also remove any debris that has accumulated under the brush cover.

1.Unplug cleaner from electrical outlet.

2.Place handle in low position and turn vacuum cleaner over so bottom side is up.

3.Remove the five screws with a Phillips head screwdriver. Lift the brush cover off.

4.Grasp rotating floor brush at both ends and lift.

Brush Cover

Motor Pulley

*The filter media, not the vacuum as a whole, complies with the IEST-RP-CC001.5 HEPA Standard

10 w w w. b i s s e l l . c o m

8 0 0 . 2 3 7 . 7 6 9 1