Bissell 33N8A, 78R5 warranty Manual cleaning

Page 10

Operations

Manual cleaning

1.Remove the hose from the unit by depressing the release button.

2.A. Remove the Tough Stain Brush from the back of the unit.

B. Attach the Tough Stain Brush onto the grip of the hose.

3.Select the hose button on the control panel to start the SpotBot.

NOTE: In manual mode, the SpotBot will not turn on until the hose is discon- nected from the hose connector. If it

is not removed within 30 seconds of pushing the hose button, the unit will shut off.

4.Begin cleaning by holding the tool no more than six inches above the soiled surface. Depress the spray trigger for about 5 seconds to apply the cleaning solution to the soiled area. Release the trigger. Be careful not to overwet.

5.Using the brush on the tool, gently scrub the soiled area until it appears to be clean.

6.To suction up the dirt and cleaning solu- tion, position the suction nozzle over the cleaned area, apply downward pressure on the tool, and pull nozzle toward you. You should see the dirty solution pass through the nozzle. Continue until no more solution can be removed.

NOTE: In manual mode, the SpotBot is equipped with a safety feature which will shut the unit off after 30 minutes. Press start to resume cleaning.

7.If the stain is still visible, repeat steps 4-6 as necessary.

8.When the cleaning is complete, lightly drag the suction nozzle across the stain to further aid in drying the cleaned area.

9.Before turning off the SpotBot, suction up clean water to thoroughly rinse out the inside of the vacuum flex hose.

Then, lift the vacuum flex hose upwards to drain any remaining water into the dirty tank.

1.

2A.2B.

3.

Tip:

One of the effective stain removing ingredients in Oxy Gen2 is Hydrogen Peroxide. Certain people may be affected by the product when it comes into contact with their skin; it may turn the skin white and/or cause tingling. Washing your hands after use and applying hand lotion will remove any possible white discoloration.

Tip:

Check upholstery stuffing before cleaning. Colored stuffing may bleed through the fabric when it becomes wet.

10 w w w . b i s s e l l . c o m

8 0 0 . 2 3 7 . 7 6 9 1

Image 10
Contents Earn Bissell Rewards Thanks for buying a Bissell SpotBot Dont forget to register your productSave These Instructions Grounding Instructions Product view Cord Underside view Special featuresFront view Back viewGetting ready OperationsThere are 2 ways you can fill and use the tank How to begin To begin cleaning Automated cleaningManual cleaning Manual cleaning continues StorageUnusual or odd noise TroubleshootingAutomated cleaning SpotBot will not run Reduce or no sprayManual cleaning Cleaner will not run Thank you for selecting a Bissell productPart Name Replacement parts Bissell SpotBotAccessories 10/11If your Bissell product should require service Warranty Bissell SpotBotLimited One Year Warranty Website or E-mail Or CallBissell Consumer Services Bissell consumer services