Bissell 8940, 1685 warranty Above, For final cleanup

Page 6
NOTE: Fill slowly to reduce sudsing.
Replace the Tank Lid, matching the Lid and Tank edges.
6. Rotate the handle to carrying position. Replace Tank in machine base, seating firmly in place. Rotate handle back down to latched position.
When It’s Time To Empty The Tank-in-Tank
NOTE: Remove the Tank-in-Tank, following steps 1 and 2 at the top of the page.
Carry the Tank-in-Tank, like a bucket, to the sink.
1. Remove Tank Lid. Pour out dirty water.
After each use, remove and rinse the Lint Screen located
2. on the Tank Lid.
A. Remove Tank Lid.
B. Remove Lint Screen and rinse under faucet. Remove any debris caught in Lint Screen.
C. Re-insert Lint Screen on Tank Lid. The screen will click into place.
D. Replace Tank Lid.
Refill with cleaning solution and clean tap water—follow
3. steps 3-5 above.
When a cleaning job is complete, rinse out the Tank-in-
4. Tank by running clean water between the bladder and the tank.
Fill to the bottom of the neck with hot tap water. Do not boil or microwave water.
Using the Measuring Cup, pour BISSELL Deep Cleaning Formula into the mouth of the bladder.
Set the Tank down and rotate the handle forward to
3. unlatch the Lid. Lift off and set the Lid aside.
4.
5.
To Fill The Tank-in-Tank
This easy-to-use system is designed with a bladder inside to hold clean water. As you clean, the bladder will empty. Dirty water collects in the tank outside the bladder.
NOTE: Make sure to add formula to the tank before filling it with water.
1. Depress the Handle Release pedal to tilt back the handle.
Lift the Tank-in-Tank™ handle. The handle locks the lid
2. in place. Carry the Tank-in-Tank™ like a bucket to fill at the sink.

Tilt Handle Back

Lift and Carry

1

2

Handle Release

 

Rotate Handle

 

3 to Unlatch

4

5

6

Lint Screen

12B

Lint Screen

2C

 

6

Return the Tank-in-Tank to the machine, follow step 6

5. above.

Refer to the Maintenance/Storage section on the next

6. page for final cleanup.

5

Latched

Tip:

A special red float device in the tank will cause the cleaner to stop removing solution from the carpet. The motor sound will rise in pitch to let you know the dirty water tank is full.

Image 6
Contents PowerSteamer Thanks for buying a Bissell PowerSteamer Important Safety Instructions OFF DirtLifter Brush How To Use This GuidePower Measuring CupFor final cleanup AboveNormal Cleaning Maintenance/StoragePump Belt Replacement To Remove Broken Pump Belt Remove the Belt Access Door. Insert a flathead To Remove Broken Pump BeltTroubleshooting Possible CausesRemedies Bissell Consumer Services Bissell Consumer Services0400 22 oz. Bissell Tough Stain PreCleaner Part Numbers And Descriptions0720 About Your Warranty If your Bissell product should require serviceUse the Customer Service tab