Troubleshooting
WARNING:
To reduce the risk of fire, electric shock, or injury, unplug machine from outlet before servicing.
Reduced spray or no spray.
Possible Causes
1Bladder may be empty
2The lint screen may be clogged
3
4Pump may have lost prime
5The Pump Belt may be broken
Lift Here
Insert
Screwdriver
Blade Here
Remedies
1Turn power OFF, refill tank with hot tap water.
2Turn power OFF, clean out lint screen, follow step 2 on page 6.
3Turn power OFF; remove and reseat tank.
4Turn power OFF; after 1 minute, turn ON and depress Spray trigger.
5Turn power OFF and unplug machine from outlet. To check if a Pump Belt has broken, you will need a flathead screwdriver. Insert the blade
end into the lower slot of the Belt Access Door to release the latch.
If necessary, insert the blade end into the upper slot to release the upper latch. Examine for belt breakage. You should be able to see the Pump Belt looped around the motor shaft. If it is broken or missing, please refer to the part numbers and descriptions on page 11 before calling BISSELL Consumer Services. Complete installation instructions will accompany the replacement belt.
PowerSteamer is not picking up solution.
Possible Causes | Remedies |
1Nozzle Window may not be properly attached
2
3
4
1Make sure the two tabs on the back of the Floor Nozzle Window are inserted through the mating slots in the main housing. Reinstall if necessary.
2Reinstall lid; refer to page 6.
3
4Empty tank and refill; refer to page 6.
Thank you for selecting a BISSELL product.
If you should happen to need assistance during assembly or operation, call:
Please do not return this
product to the store.
9