Maintenance and care (continued)
Maintaining TurboBrush
The TurboBrush should be checked regularly for clogs or debris wrapping around the brush.
1.Unplug the vacuum from electrical outlet.
2.If a clog is present or debris is visible, unscrew the two screws on the back of the TurboBrush to remove the faceplate and clear any obstructions.
3. | To clean debris from the brush, remove the | 4. | |
| brush from the drive belt and clean debris. |
|
|
4. | Reposition the drive belt on the brush. |
|
|
| Place ends of brush in slots on sides as |
|
|
| shown. Reposition faceplate and secure with |
|
|
| two screws. |
|
|
Maintaining pet hair TurboBrush
Select models only
Use for removing pet hair from stairs, upholstery, area rugs and other small areas.
1.Attach to the end of the hose or extension wand.
2.Pull toward you in a raking motion. Press gently when using the Pet Hair TurboBrush to gain maximum cleaning. Too much pressure could damage the pet hair grabbers or cause the brush to stop rotating.
See standard TurboBrush instructions above for storage and maintenance information.
NOTE: This tool is designed to remove pet hair from upholstered or carpeted surfaces. It should not be used on pets.
14 w w w . b i s s e l l . c o m
2.
8 0 0 . 2 3 7 . 7 6 9 1
9/19/06 12:31:59 PM |