Bissell 3950 warranty Replace drive belt, Replace lightbulb

Page 13

Maintenance and care (continued)

Replace drive belt

1.Unplug the vacuum from electrical outlet.

2.With rotating floor brush removed from vacuum cleaner (Steps 1-4 of check rotating floor brush and drive belt), grasp old drive belt and remove from motor pulley. Discard the old drive belt.

3.Place new drive belt over motor pulley and loop other end over rotating floor brush in the space between the bristles.

NOTE: It is important that you use only genuine BISSELL replacement belts. Generic belts may not meet the exacting specifications required to keep your vacuum operating at its peak performance. The use of unbranded belts could lead to early failure of the vacuum and could void your warranty.

3.

Motor Pulley

4.Pull the rotating floor brush firmly into position, stretching the drive belt and place ends of rotating floor brush down into the slots on sides as shown. Alignment of brush ends in slots may be necessary to fully insert the brush.

5.Turn rotating floor brush by hand several times in the direction of motor pulley. If properly installed, drive belt will center itself on rotating brush crown.

6.Insert front edge of brush cover, rotate into place, and snap 3 latches.

Replace lightbulb

1.Unplug the vacuum from electrical outlet.

2.Using a flat bladed screwdriver, pry the tab on the left and right side out and pull out to remove the lens.

3.Remove the bulb from the socket by grasping the bulb and pulling gently. Install the new bulb by pushing it gently into the socket until the bulb snaps into place.

4.Reposition the lens and snap it back into place.

2.

3.

4.

w w w . b i s s e l l . c o m

8 0 0 . 2 3 7 . 7 6 9 1

13

ug603-2145_3950_806.indd 13

9/19/06 12:31:57 PM

Page 12 Page 14
Image 13
Page 12 Page 14
Contents 5 0 S E R I E S VelocityThanks for buying a Bissell Vacuum Important Safety Instructions Curved Hose Wand Lower Hose Clip Base Wide Cleaning Foot Attach handle to vacuum Assembling your vacuumAssembling your vacuum Twist n Power switchOperations Attach vacuum hose and toolsTransporting cleaner Height adjustmentHandle positions Special on-board tools Air flow indicatorDusting Brush Upholstery Tool Curved HoseQuick Release Cord Wrap Power cord usageEmpty dirt container Maintenance and careDirt reaches the Full line on the container Empty dirt into garbage containerThoroughly before replacing Cleaning the pre-motor and post-motor Hepa media filterDetergent. Rinse well and air dry Check rotating floor brush and drive belt Maintenance and careMotor Pulley Air PassagewayReplace lightbulb Replace drive beltReposition the lens and snap it back into place Maintaining pet hair TurboBrush Maintaining TurboBrushSelect models only Clearing clogs Connecting Tube Hose Wand Base Bottom PortCleaning the upper tank Vacuum cleaner won’t run TroubleshootingVacuum cleaner and tools won’t pick up dirt Vacuum cleaner is difficult to pushM. 8 p.m. ET M. 10 p.m. ETOr write PO Box196 Replacement parts Bissell vacuumPart Name Limited One Year Warranty Warranty Bissell Velocity VacuumsIf your Bissell product should require service
Top Page Image Contents