Bissell 3950 warranty Clearing clogs, Connecting Tube Hose Wand Base Bottom Port

Page 15

Maintenance and care (continued)

Clearing clogs

Low suction or poor pickup may be due to a clog in the vacuum cleaner. If you notice a change in the sound of the motor, check for clogs.

1. Unplug the vacuum from electrical outlet.

4.

2.Empty dirt container.

3.Check upper tank for build up or clogs.

4.If you notice a clog in the upper tank, remove the separator plate (see section "Cleaning the Upper Tank" on page 16).

5.Grasp the curved wand and separate it from the hose wand base. Check for a clog in the base, the wand or in the hose.

NOTE: On select units that have the air flow indicator, when the indicator reads black, there is a clog in the hose which is diminishing suction power. Remove the clog in the hose to restore full suction power.

6.Remove the Twist ‘n Snap hose from the vacuum by turning to the right. Straighten the hose and unclog with a long, narrow object.

7.If you notice debris or dirt clogged in the connecting tube, remove it by pulling it out at the top and lifting the tube out. Clean the tube of any debris and clear any possible clog from the port to the pre-motor filter. Reattach tube by first installing the base and than push in the top of the tube.

8.If the clog persists, follow the instructions for checking the rotating floor brush and drive belt on page 12 and inspect the air passageway for obstructions.

w w w . b i s s e l l . c o m

2.

5.

Connecting

Tube

Hose Wand Base

Bottom

Port

8 0 0 . 2 3 7 . 7 6 9 1

15

ug603-2145_3950_806.indd 15

9/19/06 12:32:00 PM

Page 14 Page 16
Image 15
Page 14 Page 16
Contents 5 0 S E R I E S VelocityThanks for buying a Bissell Vacuum Important Safety Instructions Curved Hose Wand Lower Hose Clip Base Wide Cleaning Foot Attach handle to vacuum Assembling your vacuumAttach vacuum hose and tools Power switchAssembling your vacuum Twist n OperationsHeight adjustment Transporting cleanerHandle positions Curved Hose Air flow indicatorSpecial on-board tools Dusting Brush Upholstery ToolQuick Release Cord Wrap Power cord usageEmpty dirt into garbage container Maintenance and careEmpty dirt container Dirt reaches the Full line on the containerCleaning the pre-motor and post-motor Hepa media filter Thoroughly before replacingDetergent. Rinse well and air dry Air Passageway Maintenance and careCheck rotating floor brush and drive belt Motor PulleyReplace drive belt Replace lightbulbReposition the lens and snap it back into place Maintaining TurboBrush Maintaining pet hair TurboBrushSelect models only Clearing clogs Connecting Tube Hose Wand Base Bottom PortCleaning the upper tank Vacuum cleaner is difficult to push TroubleshootingVacuum cleaner won’t run Vacuum cleaner and tools won’t pick up dirtPO Box M. 10 p.m. ETM. 8 p.m. ET Or writeReplacement parts Bissell vacuum 196Part Name Warranty Bissell Velocity Vacuums Limited One Year WarrantyIf your Bissell product should require service
Top Page Image Contents