Cleaning The Upper Tank & Filter
Use only BISSELL Replacement Filters in your BISSELL
1.
The Upper Tank Filter can be reached by removing the
2. Dirt Container, reaching underneath the Upper Tank and turning the rim of the Filter Frame to unlock. Pull straight down to remove. Brush the dirt off the Louvers and Upper Tank Filter.
The foam Upper Tank Filter may be removed and hand
3. washed in cold water with mild detergent. Rinse well then air dry thoroughly before replacing.
The Upper Tank and Louvers may also be wiped clean
4. with a damp cloth.
NOTE: For easier access, the entire Upper Tank may be removed by turning the knob on the back of the cleaner to unlock and pulling the entire tank straight out.
IMPORTANT:
To maximize your cleaning performance and extend the life of your vacuum, it is very important that you check and clean your Filters frequently.
Upper
Tank
Knob
Cleaning The Pre-Motor and Post-Motor Filters
Use only BISSELL Replacement Filters in your BISSELL
HEPA Media
1.
Unplug the cleaner from electrical outlet.
The
Pre-Motor Filter
2. It is located in the slide out tray underneath the Dirt Container. If the Filter becomes dirty, pull out the tray, lift out the Filter and clean. This Filter may be hand washed in cold water with mild detergent. Rinse well and air dry thoroughly before replacing.
The HEPA Media Post-Motor Filter assists in the filtration
3. process to return clean air to the room. It is located behind the door on the back of the cleaner. If the Filter becomes dirty, open the door, remove the Filter and replace. The HEPA Media Filter is not washable.
Hepa Media 
WARNING:
Do not operate cleaner with damp or wet Filters or without all Filters in place.
10