Maintenance and care
Clearing clogs continued
If the clog is contained near the bottom of the hose (close to where tools are attached), follow these steps:
1.Remove wand or tool.
2.Attach hose to the blower outlet and turn the power on.
3.This should dislodge the clog by blowing out debris.
If the above methods are not successful, find the clog by hand, then squeeze the hose and shake until the debris dislodges.
Tool maintenance
Keep tools clean and free of debris.
1.Wipe tools clean with damp cloth.
Note: The multi surface floor tool contains a strip of red material that should not get wet. If it needs cleaning, wipe with damp cloth only.
SERVICING OF DOUBLE-INSULATED APPLIANCE
A
In a
12 w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1
4/17/08 4:44:10 PM