Troubleshooting
Vacuum cleaner won’t turn on
Possible causes
1.Power cord not plugged in
2.Blown fuse/tripped breaker in home
3.Thermal protector activated
4.Dirt tank is full of water
5.Dirt tank is full of debris
WARNING:
To reduce the risk of electric shock, turn power OFF and disconnect polarized plug from electrical outlet before performing maintenance or troubleshooting.
Remedies
1.Check electrical plug
2.Check/replace fuse or reset breaker
3.Allow cleaner to cool for 30 minutes, see pg 8. This will reset thermal protector
4.Empty tank and reattach
5.Empty tank and reattach
Vacuum cleaner and tools won’t pick up or low suction
Possible causes | Remedies | ||
1. | Hose not properly positioned | 1. | Make sure hose is fully connected to base |
2. | Dirt tank not installed properly | 2. | Check assembly of upper and lower portions, |
|
|
| correctly position and secure into place |
3. | Dirt tank full | 3. | Empty dirt tank |
4. | Clog in cleaner | 4. | Follow instructions on pg 11 and 12 for |
|
|
| clearing clogs |
5. | Filters are dirty | 5. | Check and clean filter |
6. | Hose not properly attached | 6. | Make sure hose collar is pushed in or in |
|
|
| locked position |
7. | Vacuum is not suctioning or blowing | 7. | Make sure hose is in correct inlet/outlet |
Other maintenance or service not included in the manual should be performed by an
authorized service representative.
Thank you for selecting a BISSELL product.
If you should happen to need assistance during assembly or operation, call
Please do not return this product to the store.
For any questions or concerns, BISSELL is happy to be of service.
Contact us directly at
w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1 | 13 |
4/17/08 | 4:44:10 PM |