Assembly
Mounting & installation continued
Concrete Wall (fasteners not included)
You will need; (4) 3/8” x
1. Drill a 3/8” x
2. Insert a bolt and anchor sleeve into the hole.
3. Align the bracket over the hole and mark remaining hole locations using the (4) outer holes of the mounting bracket; remove bracket and drill remaining holes.
4. Mount the bracket starting at top corner hole, tightly securing sleeve anchor with hex nut.
5. Repeat for three remaining holes.
6. Mount the unit by making sure the two square slots on backside of unit are sitting on the two hooks on the mounting bracket.
Mounting the Hose Holder (fasteners included)
1. Determine desired location for hose holder and screw
(If mounting into drywall with no stud available, use supplied drywall anchors)
2. Hang holder from screw and insert
3. Wrap hose around holder.
Use (4) Outer Holes To Mount Bracket
Slots
Operation
Power switch
The power switch is located on the top left side of the vacuum.
To turn vacuum on, ( I ) press up.
To turn vacuum off, ( O ) press down.
6 w w w . b i s s e l l . c o m
WARNING:
Do not remove plastic covering on power switch.
Power Switch
8 0 0 . 2 3 7 . 7 6 9 1
4/17/08 4:43:09 PM