Assembly
Your deep cleaner comes in two easy to assemble components:
1.Upper handle
2.Portable spot cleaner/Base
The only tool you will need to assemble your cleaner is a Phillips screwdriver.
1.Slide the upper handle onto the body of the machine by guiding the 2 posts on the body into the opening on the upper handle.
2.Firmly holding the upper handle in place, screw 2 screws into the marked holes at an upward angle above the support handle.
3.At an upward angle, screw the remaining 2 screws into the marked outermost holes under the support handle.
4.Wrap power cord around Quick Release Cord Wrap.
5.Wrap flex hose around the hose wrap and secure with hose secure latch.
6.Align the product as image 4 shows and firmly push down the portable spot cleaner until it is secured on both sides.
7.Check latches on both sides to confirm it is secured (5).
To further check if the portable spot cleaner is secure, plug in and turn on to verify that the heat indicator light is illuminated. If the heat indicator light does not illuminate, release the pod and
8.Snap attachment(s) into the back of unit.
NOTE: Portable spot cleaner must be fully secure to operate in the upright mode.
1.2.
1. | 2. |
Slide the upper handle onto | Firmly holding the upper |
3.4.
CordHose
sideside
At an upward angle, screw
5.
Warning:
Do not plug in your cleaner until you have completely assembled it per the above instructions and are familiar with all instructions and operating procedures.
6 w w w. b i s s e l l . c o m | 8 0 0 . 2 3 7 . 7 6 9 1 |