Bissell 66E1 warranty Portable spot cleaning mode continued, Replacing portable machine on base

Operations

Portable spot cleaning mode continued

Cleaning with Deep Reach™ Tool
1.	Set tool on soiled surfaces and press the	1.
	trigger to spray solution onto the soiled
	area to be cleaned.
2.	Slowly move the tool back and forth
	over the soiled surface, keeping the tool
	in contact with the carpet.	3.
	Release trigger and move tool slowly
	over the soiled area to suction up
	water and dirt.
4.	Continue to clean the area, working
	in small sections, until no more dirt
	can be removed.

Empty dirty tank

Follow the instructions under Empty dirty tank section on page 9 of the Upright cleaning mode section.

Replacing portable machine on base

1.Align the product with the cord side on the left and hose side on the right.

2.Push down the portable spot cleaner until both sides click securely into place. Test the fit by pulling up on the carry handle to make sure it is secure. To further check if the portable spot cleaner is secure, plug in and turn on to verify that the heat indicator light is illuminat- ed. If the heat indicator light does not illuminate, release the pod and re-secure by pushing firmly until both sides snap into place.

1.

Cord	Hose
side
	side

Cleaning portable machine

1.Remove and rinse the tools in clean, running water. Dry and replace in the tool storage provided.

2.It is recommended that you suction clean water from a bowl to rinse out the hose. Then lift end of hose and stretch out to ensure all water is cleared from hose.

3.Coil flex hose around the hose wrap and secure with latch.

4.Check suction gate and if it appears dirty, follow steps 1-4 under Cleaning Suction Gate on page 13.

12