Assembly
The only tool you'll need to assemble your vacuum cleaner is a Phillips head screwdriver.
1.Slide upper handle into lower handle by pushing forward. Insert two long screws into the holes marked with arrows and tighten both until snug.
2.Attach hose rack by placing the rack over the center back portion of the vacuum. Be sure to feed the power cord through the hole in the center of the rack. Line up both screws holes and use the two smaller screws to attach. Tighten both until snug.
3.Attach hose by placing the tabbed end of the hose cuff into the opening on the bottom left side of the vacuum. Make sure the tab on the hose cuff and the hole in the opening line up and snap into place. Place the working end of the hose into the opening on the lower right side of the vacuum. Push down firmly until it locks into place.
4.Arrange the hose so it lays between the vacuum and the rack.
5.Store the TurboBrush on the front of the handle by aligning the slot on the bottom with the tab on the handle. Snap into place.
6.Store the combination brush in the slot on the back of the vacuum as shown.
7.Store the extension wand in the storage area on the side of the vacuum. The crevice tool is stored inside the extension wand.
12a
2b3
5
w w w . b i s s e l l . c o m | 165 |