Bissell 1716 warranty Tip

Page 7
Check the Dirty/Collection tank and empty the tank if it is full (See Clean Up/ Storage, page 8).
Press the front of the SpotLifter PowerBrush firmly against the surface to vacuum the cleaning solution.
Press the Manual Trigger Spray to apply the cleaning solution.
Press the front of SpotLifter PowerBrush firmly against surface to vacuum the spill.
1.
2.
3.
4.
5.
If the SpotLifter PowerBrush stops spraying, turn off the
6. unit and check the Cleaning Solution level in the Clean/Solution Tank. Refill if needed. Never run dry.
Turn the unit on to activate the suction.
If manufacturer’s tag is missing or not coded, check with your furniture dealer.
If possible, check upholstery stuffing. Colored stuffing may bleed through fabric when wet.
Cleaning Spills From Hard Surfaces
2.
3.
Cleaning Continued
Brushing and Suction can be done separately, based on
4. how you hold and use the unit.
To Use The Dual Powerbrushes Only:
Tilt the unit forward slightly, placing both brushes in con- tact with the carpet. The flat surface of the brush car- tridge should be parallel to the surface being cleaned
For Suction Only:
Tilt the unit forward, pressing the front of the Spotlifter Powerbrush firmly against the surface area to be cleaned, lifting the brushes up off the surface. Pull toward you to remove the soil and cleaning solution.
Note: Step #4 may be repeated until no more dirty water is removed or until the area to be cleaned meets your satisfaction.
Check the Dirty/Collection tank and empty the tank if it is
5. full (See Clean Up/Storage, page 8).
If the Spotlifter PowerBrush stops spraying, turn off the
6. unit and check the Cleaning Solution level in the Clean/Solution Tank. Refill if needed. Never run dry.
Deep Cleaning Upholstery
1.
Check manufacturer’s tag before cleaning. “W” or “WS” on the tag means you can use your SpotLifter PowerBrush. If tag is coded with an “S” (with diagonal strike-through) or states “Dry Clean Only”, do not proceed.

Tip:

You may also spray water and formula, with the Manual Trigger Spray, while the unit is turned on and you are using the Dual PowerBrushes and Suction to clean.

Tip:

Fast attention to a spill on upholstery can prevent permanent staining.

Tip:

When cleaning a vertical surface (ie chair back, auto interior, etc.) begin with a completely empty Dirty/Collection Tank.

7

Image 7
Contents E R ’ S G U I D E SPOTlifterM. 8 p.m. ET Thanks for buying a Bissell SpotLifter PowerbrushBissell Consumer Services Bissell Consumer ServicesThis appliance To reduce the risk of fire, electric shock or injury Product View Water AssemblyThere are no steps required for assembly = on positionPre-Treating CleaningTip To Empty the Dirty/Collection Tank Clean-Up/StorageTo Clean the Dual Powerbrushes First you need to remove the Clean/Solution Tank. GentlyReplace the belt cover door To Replace the PowerBrush BeltStore in a dry area, at room temperature to avoid freezing Putting It AwayTank is past full line TroubleshootingPossible Causes RemediesPart Name Replacement Parts799 Limited One Year Warranty About Your Warranty
Related manuals
Manual 12 pages 14.41 Kb