Clean-Up/Storage
|
|
| Turn the power switch to the “OFF” position. ( O ) |
1. | |||
|
|
| Unplug the unit. |
2. |
| ||
|
| Carry the SpotLifter PowerBrush to the sink or drain. | |
3. |
|
To Empty the Dirty/Collection Tank
First you need to remove the Clean/Solution Tank. Gently
1. press the Quick Release tabs on the Clean/Solution Tank and slide the tank off of the unit.
2.
While at the sink, remove the Tank Cap by turning
3. approximately 1/4 turn counterclockwise and lift out the cap.
Empty the tank. Rinse the Dirty/Collection tank with
4. warm water.
Replace cap and turn approximately 1/4 turn clockwise,
5. until snug.
Slide the Dirty/Collection Tank into the unit. Replace the
6. Clean/Solution Tank.
Note: If a significant amount of water and formula remains in the Clean/Solution Tank, you may leave it in the Clean/Solution Tank for your next cleaning task.
To Clean the Dual Powerbrushes
NOTE: Make sure the Power Switch is in the “OFF” position. ( O )
Firmly grasp the Brush Cartridge from the side of the
1. unit and pull out from the unit.
To remove any debris that may have collected around
2. the Dual Powerbrushes, rinse the Brush Cartridge under warm water.
Replace the Brush Cartridge into the unit by gently
3. guiding the Cartridge in the unit. Once it is in place, firmly “snap” the Brush Cartridge in place.
1.
2.
3.
1.
2.
8
NOTE: Do not attempt to remove or insert the Brush Cartridge while the unit is running. This will damage your unit.