Maintenance and care
TurboBrush Tool maintenance
The TurboBrush Tool should be checked regularly for clogs or debris wrapping around the brush.
Note: Model 30C7T comes with the Pet TurboBrush Tool and follows same maintenance instructions.
1.Remove tool from hose or from vacuum.
2.Twist collar so opening is at the top and lift top cover to remove.
3.Remove the brush from the belt and clean debris.
4.Replace the brush inside the belt and place ends into slots on sides.
5.Reposition top cover making sure to line up inside tab at the front with the opening on the cover. Twist collar until opening is at the bottom to lock into place.
2.
4.
5.
Tip:
TurboBrush® may not be turning due to loss of suction. Refer to pg. 11 for checking and clean- ing clogs.
15
w w w . b i s s e l l . c o m | 8 0 0 . 2 3 7 . 7 6 9 1 |