Assembly
Attach storage clips, tool, and vacuum hose continued
5.Make sure that crevice tool is inside the extension wand. Store the extension wand and crevice tool on the back of the unit. Place tools on the extension wand support and push toward the back of the unit until clip holds tools in place.
6.Slide the dusting brush into the storage clip on the left side of the unit (when viewing from back.)
7.Place the TurboBrush Tool in the hole marked “tool” on the top of the handle arch.
Operations
Handle Positions
Using your foot, press the handle release pedal, located on the lower left side of the vacuum, to recline the vacuum.
Transporting your cleaner
1.To move your cleaner from room to room, put the handle in the upright position, tilt the cleaner back on its rear wheels and push forward.
2.The cleaner can also be moved by using the carry handle on the front.
Power Cord
To store power cord, wrap cord around the upper cord wrap and lower extension wand support. Once wound tightly use the clip on the end of the plug to attach the plug to the cord.
To release the power cord, rotate the upper cord wrap down and gently pull the power cord off of the upper cord wrap.
Power switch
The power button is located on the left side (when viewing from back) of the vacuum. Push the rocker switch “ON”
(I)to vacuum, and “OFF” (O) when cleaning is complete.
| Note: The rotating brush will not |
| turn on unless the unit is in the |
| reclined position and the brush |
6 | switch is on. |
|
TurboBrush®
Tool
Stretch Hose
Crevice Tool
Extension
Wand
Dusting/
Upholstery
Tool
1 2
Caution:
Before using your vacuum, Make sure both filters
Power Switch
w w w . b i s s e l l . c o m | 8 0 0 . 2 3 7 . 7 6 9 1 |