Maintenance and care
Clearing Clogs
Low suction or poor pickup may be due to a clog in the vacuum cleaner. If you notice a change in the sound of the motor or a reduction in the spinning action in the dirt container, check for a clog.
If there is no suction or if suction is reduced at the hose, follow these steps to check for and clear the clog.
1.Turn power switch off.
2.Unplug cleaner from electrical outlet.
3.Check the
4.Check the post motor filter cartridge and replace if necessary (see replacing your
5.Check upper tank for build up or clogs. If you notice a clog in the upper tank, remove the inner cyclone (see cleaning the dirt container on page 9).
6.Grasp the hose wand and separate it from the hose wand base. Check for a clog in the base, the wand, or in the hose.
7.Remove the Twist ‘n Snap hose from the vacuum by turning to the left. Straighten the hose and unclog with a long, narrow object such as a broom handle.
8.If the clog persists, follow the instructions for checking the rotating floor brush and drive belt on page 13 and inspect the air passageway for obstructions
If suction is normal in the hose, check for and clear the clog for floor cleaning:
1.Check the foot hose for clogs.
2.If you are not able to tell from the outside if a clog is present, remove the screw at the top left of the foot hose. Lay the foot hose flat and unclog with a long, narrow object such as a broom handle.
Remove any clogs found and fully reassemble the cleaner before attempting to check suction again or using the cleaner.
CAUTION:
To reduce the risk of injury from moving parts, turn off vacuum cleaner and disconnect power plug from electrical outlet.
11
w w w . b i s s e l l . c o m | 8 0 0 . 2 3 7 . 7 6 9 1 |