Bissell 32N3 warranty Maintenance and care, Dust bag replacement

Page 8

Maintenance and care

Dust bag replacement

1.Unplug the vacuum from electrical outlet.

2.Open the dust bag compartment by lifting up on the latch on the door on the front of the vacuum, until the door locks into place.

3.Close the filter bag by pulling the card- board strap. This serves to cleanly seal the full dust bag. Lift out the dust bag holder and dust bag by pulling vertically on the convenient handle, located on top of the dust bag holder.

4.Release the dust bag from the holder by grasping the cardboard strap, which was used to seal the full dust bag, and pulling to the right, removing the dust bag out of the holder. Discard the used dust bag.

5.Slide the new dust bag into the holder by inserting the dust bag into the tabs located at the bottom of the holder. Make sure the dust bag has slid completely into place for proper use.

6.Place holder and new dust bag back into the dust bag compartment, making sure the entire bag is tucked in below the seal gasket.

7.Close dust bag compartment door and press down gently until it locks into place.

NOTE: The dust bag compartment door will not close without the dust bag in place.

2.

3.

WARNING:

To reduce the risk of electric shock, turn power switch OFF and disconnect plug from electrical outlet before performing mainte- nance or troubleshooting checks.

Replacing the HEPA media pre-motor filter

The HEPA media pre-motor filter protects the motor from dirt and dust particles and assists in the fil- tration process to return clean air to the room.

1.Unplug the vacuum from electrical outlet.

2.Open the dust bag compartment by lifting up on the latch on the door at the front of the vacuum until the door locks into place. Lift out the dust bag holder and dust bag.

3.Remove the filter frame from the filter holder by grasping the lip of the frame and pulling up.

NOTICE:

This product is intended for house- hold use only and not for commer- cial or industrial use. Vacuuming of dust from products like plaster, concrete or ashes will damage the motor and void the warranty.

HEPA media Pre-Motor Filter

3.

8w w w . b i s s e l l . c o m

Image 8
Contents Users Guide Thanks for buying a Bissell PurePro Compact Vacuum Important for Product view Assembly Power cord Power button0perations Automatic cord rewindVariable suction power control Bag change indicatorHigh filtration dust bag Crevice toolReplacing the Hepa media pre-motor filter Maintenance and careDust bag replacement Tip Replacing the post-motor micro filterTroubleshooting Vacuum cleaner won’t runVacuum cleaner won’t pick up or low suction Thank you for selecting a Bissell productReplacement parts Bissell vacuum Part NameWarranty Bissell PurePro vacuum