Bissell 3522 warranty Vacuum cleaner won’t run, Troubleshooting, Possible Causes Remedies

Page 10

 

Clearing Clogs

 

The Hose on the back of the vacuum cleaner that carries

Suction

the dirt from the Powerfoot to the Dust Bag can sometimes

become clogged. If you notice a change in the sound of the

Inlet

vacuum motor, check for clogs.

 

1.

Unplug cleaner from electrical outlet.

 

2.

Pull the Bag Door outward to open and set aside. Remove the

 

 

Dust Bag to check the Suction Inlet for a clog.

 

3. Grasp the Quick Reach Handle and lift up to separate from the Suction Intake Opening. Check for a clog in the Base, the Wand or the Hose.

For models with the Twist ‘n Snap Hose. Release the hose from the vacuum by turning to the right. Straighten the hose and unclog with a long, narrow object.

4. If the clog persists, turn the vacuum cleaner OFF and unplug

 

it. Remove the Brush Cover. Check the Air Passageway for

Air Passageway

obstructions. Remove debris from this area. Reposition

Brush Cover and four screws. Tighten screws securely.

 

Make sure end of Brush Cover is snapped into place.

 

Troubleshooting

WARNING:

 

 

To reduce the risk of

 

injury from moving parts

 

and/ or electrical shock,

 

turn Power Switch OFF

 

and disconnect polarized

 

plug from electrical outlet

 

before performing

Vacuum cleaner won’t run

troubleshooting checks.

Possible Causes

Remedies

1

Power cord not firmly plugged in

1

Check electrical plug.

2

Blown fuse/tripped breaker

2

Check/Replace fuse or reset breaker.

Vacuum cleaner won’t pick up dirt

Possible Causes

1Incorrect Height Adjustment

2Hose not attached to suction opening

3Twist 'n Snap Hose not securely attached

4Dust Bag is Full

5Rotating Floor Brush bristles worn

6Rotating Floor Brush jammed

7Clog in vacuum

Remedies

1Adjust Powerfoot to correct height setting.

2Grasp Hose Grip and firmly push onto the base.

3Make sure Twist 'n Snap Hose is snapped into the locked position.

4Replace with new Dust Bag.

5Replace brush.

6Remove brush and clean debris from brush ends.

7Follow instructions for clearing clogs.

10

Image 10
Contents PowerForce Thanks For Buying a Bissell PowerForce Important Safety Instructions Risk of fire, electric shock, or injuryCrevice Tool Attach Handle To Vacuum How To Use This GuideHow To Assemble Attach Vacuum Hose and ToolsSpecial Tools How To Use Your Bissell PowerForce Handle PositionPowerfoot Height Adjustment Place Handle in Upright PositionPower Cord Routine MaintenanceIndicator Bag Change IndicatorFilter Never reuse a Dust BagPre-Motor Replace Dust BagCheck Rotating Floor Brush and Drive Belt Motor Pulley Air PassagewaySmall Bulb Brush Cover Large Bulb Replace Drive BeltVacuum cleaner won’t pick up dirt Possible Causes Vacuum cleaner won’t runTroubleshooting Possible Causes RemediesReplacement Parts Bissell PowerForce Tools wont pick up dirtWarranty Limited One Year WarrantyBissell Consumer Services If your Bissell product should require service