How To Use This Guide
This User’s Guide has been designed to help you get the utmost satisfaction from your BISSELL PowerForce. You’ll find assembly and operating instructions, safety precautions, as well as maintenance and troubleshooting instructions. Please read this Guide thoroughly before assembling your vacuum cleaner.
Pay particular attention to the product diagram, assembly instructions, and part names. Locate and organize all parts before assembly. Following this User’s Guide will greatly enhance your ability to get the most performance from your BISSELL PowerForce for many years.
WARNING:
Plastic film can be dangerous. To avoid danger of suffocation, keep away from babies and children.
How To Assemble
The only tool you’ll need to assemble your vacuum cleaner is a screwdriver.
1.
Attach Handle To Vacuum
1.Stand the vacuum upright and slide the base of the Handle firmly into the grooves at the top of the vacuum body.
2.Check to be sure the Handle is fitted to the vacuum body. If there is a gap in front, continue to push firmly until the Handle is flush.
3. | Insert one screw from the assembly packet into the |
|
| existing hole in the back of the Handle. Tighten securely | 1. |
| with a screwdriver. | |
|
|
3.
Hose
Collar
Attach Vacuum Hose and Tools
1.Position the Hose Assembly on the back of the vacuum as shown.
2.Attach the Hose Collar with two screws from the assembly packet. Tighten securely with a screwdriver.
2. |
3. | Line up the tabs on the base of the Twist ‘n Snap Hose | 3. |
| with the corresponding tab notches on the hose collar as |
|
| shown. Turn the Twist ‘n Snap Hose to the left to lock the |
|
| hose into place. |
|
4. | Grasping the Quick Reach® Handle, slide the end |
|
| of the Hose Wand onto the Suction Intake Opening. | 4. |
| Snap the Hose into the Hose Clip. | |
| NOTE: The Powerfoot will not operate |
|
| effectively unless the Hose Wand is firmly |
|
| attached to the Suction Intake Opening. | 5. |
|
| |
5. | Place the Crevice Tool inside the Extension Wand and | 6. |
| slide them into the Storage Clip as shown. |
|
6. | Snap the Combination Upholstery/Dusting Brush Tool |
|
| into the Storage Clip as shown. |
|
5