Troubleshooting
Vacuum cleaner won’t run |
|
| |
| Possible Causes | Remedies |
|
| Vacuum cleaner is not plugged in | Check electrical plug |
|
| Household fuse/breaker | Check/replace fuse - |
|
|
| Reset breaker button |
|
Vacuum cleaner won’t pick up dirt |
|
| |
| Possible Causes | Remedies |
|
| Dust Bag is full | Replace with new bag |
|
| Rotating Brush Drive Belt broken | Replace Drive Belt (See page 10) |
|
| Drive Belt stretched | Reposition belt/clean brush/belt areas |
|
| off Motor Pulley Shaft | (See page 10) |
|
|
| If Belt is stretched, it should be replaced |
|
|
| (See page 10) |
|
| Rotating Floor Brush bristles worn | Replace brush (See page 10) |
|
| Rotating Floor Brush jammed | Remove brush and clean debris from |
|
|
| brush ends (See page 10) |
|
Height adjustment too high
Air Passageway clogged
WARNING: To
reduce the risk of injury from moving parts and/ or electrical shock, turn power switch OFF and disconnect polarized plug from electrical outlet
b e f o r e p e r f o r m i n g troubleshooting checks.
Reset Height Adjustment
Remove Brush Cover. (See page 10) Clean debris from passageway
If still clogged: Remove Vacuum Body from Powerfoot.
Directions: 1. Remove screw from front of Vacuum Body (reverse of step 3. in How To Use section.)
2.Gently insert blade of flathead screwdriver underneath the plastic tab on the back of the Vacuum Body to lift past the raised area inside the rectangular opening.
3.Pull upward on Vacuum Body handle and lift Vacuum Body off of Powerfoot. Remove blockage.
Tools won’t pick up dirt |
|
| ||
|
| Possible Causes | Remedies | |
|
| Vacuum Flex Hose clogged | Visually check for objects blocking | |
|
|
| suction path and remove carefully | |
Vacuum cleaner is difficult to push |
|
| ||
|
| Possible Causes | Remedies |
|
|
| Incorrect Height setting | Dial Adjustment to next highest setting | |
12