How to use your BISSELL PowerClean
Tip:
Before cleaning under low furni- ture, check for objects that might harm the rotating floor brush or block the vacuum hose. Do not pick up hard or sharp objects such as glass, nails, screws, coins, paper clips, etc.
Power Cord Quick Release
The Power Cord is stored at the back of the Vacuum Body, looped around two Cord Wraps. A molded clip on the polarized plug allows it to be fastened to the Power Cord during storage.
1.Unclip polarized plug from Power Cord.
2.Rotate the Upper Cord Wrap
3.Connect Power Cord Plug with a polarized outlet.
4.To keep the Power Cord out of your way while cleaning, place it in the cord hook near the top of the handle.
Power Switch
The Power Switch is located just below the hand grip. Push the rocker switch “ON” to vacuum, and “OFF” when cleaning is complete.
Powerfoot Height Adjustment
You can adjust the Powerfoot/Rotating Floor Brush of your
BISSELL Upright Vacuum to clean several floor surfaces.
1.Place Handle in Upright Position (see Handle Positions, Page 7).
2.Move Height Adjustment to desired setting.
■HI - For plush pile or shag carpet.
■BARE FLOOR - For smooth floors without carpet.
Do not adjust vacuum cleaner too low in deep pile or shag carpet. This can overload motor and damage rotating floor brush or drive belt.
Handle Positions
Press the Handle Release Pedal at the back of the Powerfoot to |
|
|
|
|
|
place your PowerClean into one of three cleaning positions. |
|
|
|
|
|
1. Upright - For storage and above floor cleaning with |
|
|
|
|
|
special tools. |
|
| 1. | ||
| |||||
2. Normal Cleaning - Use for most household floor |
|
|
|
|
|
cleaning tasks. | 2. |
|
| ||
3. Low Cleaning - Use for vacuuming under low furniture |
|
|
|
|
|
such as tables, chairs and beds. |
|
|
|
|
|
NOTE: The handle will not lock in the Normal or |
|
|
|
|
|
Low cleaning positions. | 3. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
6