Maintenance and care
Clearing clogs
Low suction or poor pickup may be due to a clog in dirt cup. If this occurs, follow these steps to check for and clear clog:
1.Unplug unit from electrical outlet. Ensure power is OFF.
2.Check foam filter and clean as necessary (see Cleaning the filters on page 6)
3.Check pleated filter and replace if necessary (see Cleaning the filters on page 6)
4.Check to see if dirt cup is full. Empty if needed.
5.Check to see if air duct in dirt cup and exhaust inlet to motor are clear of all debris. Clear debris if needed.
6.Replace filter and dirt cup assembly.
Brush and wiper maintenance
Regularly check rear angle brush and front wipers on underside of the unit to keep clean. Wipe any debris that has accumulated on angled brush or front wipers with a damp cloth.
1.Unsnap rear angled brush by pulling up from one side. Replace with a new brush by snapping into track.
2 . To remove wipers, slide old wiper out and insert new wiper.
Note: Any other servicing should be performed by an authorized service representative.
w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1 | 7 |
5/30/08 | 10:30:19 AM |