Rheem Solar Loline Conversion Kit Electric Wter Heater Connections Electrical, Thermostat Setting

Page 32

CONNECTIONS - ELECTRICAL

The power supply must not be turned on until the solar storage tank is filled with water, and a satisfactory megger reading is obtained. The solar storage tank with an electric booster heating unit is designed for direct connection to a 240 V AC 50 Hz mains power supply with an isolating switch installed at the switchboard.

Flexible 20 mm conduit is required for the electrical cable to the solar storage tank. The conduit is to be connected to the unit with a 20 mm terminator. Connect the power supply wires directly to the terminal block and earth tab connection, ensuring there are no excess wire loops inside the front cover.

The solar control unit, supplied with a 1.8 metre power cord, requires a 240 V general power outlet (GPO) to be located within 1.2 metres of the installation. The GPO is required to be weatherproof for outdoor installations. If the power supply cord is damaged, it must be replaced in order to avoid a hazard.

ASSEMBLY OF ADJUSTER MECHANISM ON OPTIMA MODELS When the front cover has been removed,

reassemble as follows:

￿￿Remove the knob from the front cover by depressing the locking tabs on the inside of the front cover.

￿￿Turn the thermostat to the lowest

temperature (refer to “Temperature Adjustment – Optima” on page 5).

￿￿Fit the front cover.

￿￿ Insert the connector shaft through the

hole into the thermostat adaptor slots.

￿￿Align the knob slots over the ‘T’ drive on the connector shaft, with the dial at the lowest setting – a firm push with the hand on the knob front face will engage the locking tabs.

THERMOSTAT SETTING

The water heater thermostat should be set at the lowest temperature that will provide sufficient hot water. Discuss with the user to determine the lowest thermostat setting to ensure sufficient quantities of hot water. Dishwasher running costs can be adversely affected if the thermostat is set below 65￿C. The thermostat can be adjusted within the range shown on page 4.

32

Page 31 Page 33
Image 32
Page 31 Page 33
Contents Owners Guide Installation Instructions Patents Contents About Your Water Heater Model TypeHotter Water Increases the Risk of Scald Injury To Turn OFF the Water HeaterHOW Long will the Water Heater LAST? To Turn on the Water HeaterDoes the Water Quality Affect the Water HEATER? Anode Protection Flushing the Solar Collectors Freeze ProtectionTemperature and Pressure Relief Valve SafetyRegular Care Expansion Control ValveElectric Boosting HOW Your Water Heater WorksMains Pressure Single Element Models Twin Element ModelsContinuous Tariff Connection Manual ON/OFF SwitchManual Controls ONE Shot Control Switch Going on HolidaysSave a Service Call Not Enough HOT Water or no HOT WaterWater not HOT Enough Temperature and Pressure Relief Valve Running Normal OperationContinuous dribble Steady flows for long period often at nightCollector Glass High Electricity BillsElectricity Tariffs Installation Solar Storage Tank Safe Tray Max. mains supply pressureTank Water Supply HOT Water DeliveryReducing Heat Losses Anode TypesSaddling Pipe Work Booster Heating UnitAssembly of Cold Water Supply and Solar Pipe Connections HOT Water OutletCold Water Inlet Relief ValveRheemglas Indoor Location Outdoor Location Installation Solar Control Unit Solar Conversion of a Rheem Electric Water HeaterSolar Storage Tank with Solar Control Unit Installation of Solar Collectors Supplied in Solar Loline Conversion KITLatitude of Some Australian Cities Installation Solar CollectorsSolar Collector Location Connections Plumbing Connection SizesINLET/OUTLET Connections Pipe SizesPipe Lengths Relief Valve Drain Bleed Valve DrainExpansion Control Valve Thermostat Setting Connections ElectricalManual Controls Bleeding the Solar Collectors CommissioningTo Fill and Turn on the Water Heater To Turn OFF the Water Heater Draining the Solar Collectors Draining the Water HeaterPage Water Supplies AnodeRheem Solar Water Heater Warranty Australia only Cylinder from date of installation Rheem will

Solar Loline Conversion Kit Electric Wter Heater specifications

The Rheem Solar Loline Conversion Kit for electric water heaters is a remarkable solution that integrates solar energy into water heating systems, facilitating a more sustainable and efficient way to heat water. This innovative kit is designed specifically to convert existing electric water heaters into solar-compatible units, enabling homeowners to harness the power of the sun for their hot water needs.

One of the main features of the Rheem Solar Loline Conversion Kit is its compatibility with various electric water heater models. This flexibility allows homeowners to enhance their existing systems without the need for complete replacement, making it a cost-effective choice for many. The kit includes all necessary components required for the installation, including a solar controller, a solar pump, and the required plumbing fittings, ensuring a seamless upgrade process.

This conversion kit utilizes advanced technologies to maximize energy efficiency. The solar controller optimizes the operation of the system by monitoring the temperature of the water in the storage tank and the solar collectors, ensuring that the water is heated when sufficient solar energy is available. This intelligent management helps reduce electricity consumption, leading to significant savings on energy bills.

In terms of characteristics, the Rheem Solar Loline Conversion Kit boasts high-quality construction and reliable performance. The durable components ensure a long lifespan and minimal maintenance, making it a wise investment for environmentally-conscious homeowners. The solar pump, designed for efficiency, enhances the movement of water between the solar collectors and the storage tank, ensuring optimal heat transfer and system performance.

Moreover, the kit promotes sustainability by reducing reliance on fossil fuels and decreasing carbon emissions. By utilizing solar energy for water heating, homeowners can significantly lower their environmental impact while enjoying the benefits of hot water on demand.

In conclusion, the Rheem Solar Loline Conversion Kit for electric water heaters presents an excellent opportunity for homeowners to embrace solar energy. With its compatibility, advanced technologies, and eco-friendly characteristics, this conversion kit stands as an ideal solution for those looking to enhance their water heating systems while contributing to a greener future. Whether for new installations or retrofitting existing systems, the Rheem Solar Loline Conversion Kit is designed to meet modern demands for efficiency and sustainability.
Top Page Image Contents