Rheem Solar Loline Conversion Kit Electric Wter Heater Water Supplies, Anode

Page 38

WATER SUPPLIES

Your Rheem water heater is manufactured to suit the water conditions of most Australian metropolitan supplies. However, there are some known water supplies which can have detrimental effects on the water heater and its operation and/or life expectancy. If you are unsure of your water quality, you can obtain information from your local water supply authority.

ANODE

By using the correct colour coded anode this water heater can be used in areas where the total dissolved solids (TDS) content in the water is up to 2500 mg/L. In areas where the TDS exceeds 600 mg/L it is possible the black anode, which is the standard anode fitted to the water heater, may be excessively active. To alleviate this, the black anode should be replaced with one colour coded blue. Where the TDS of the water is less than 40 mg/L, such as when the water has been deionised or is from an alpine supply, a high potential anode, colour coded green, should be used. The changing of anodes must be carried out by a plumber or authorised service person.

CAUTION

If your water supply has a TDS greater than 600 mg/L and the anode has not been changed to a blue one, there is the possibility hydrogen gas could accumulate in the top of the water heater during long periods of no use.

If, under these conditions, the water heater has not been used for two or more weeks the following procedure should be carried out before using any electrical appliances (automatic washing machines and dishwashers) which are connected to the hot water supply.

The hydrogen, which is highly flammable, should be vented safely by opening a hot tap and allowing the water to flow. There should be no smoking or naked flame near the tap whilst it is turned on. Any hydrogen gas will be dissipated. This is indicated by an unusual spurting of the water from the tap. Once the water runs freely again, any hydrogen in the system will have been released. In areas where this is likely to occur, the householder should be instructed by the installer on how to dissipate the gas safely.

SATURATION INDEX

The saturation index is used as a measure of the water’s corrosive or scaling properties. In a scaling water supply calcium carbonate is deposited out of the water onto any hot metallic surface. When water has a saturation index greater than +0.40 an expansion control valve* must be fitted on the cold water supply after the non-return valve and the solar collectors should be covered when the water heater is not intended to be used for extended periods.

Where the saturation index exceeds 0.80, a water softening device and a low watts density element should be fitted. Where the saturation index is less than –1.0, a corrosion resistant heating unit should be used (contact your nearest Rheem Service Department or Accredited Service Agent).

* Refer to the cold water connection detail on page 21.

WATER HEATERS NOT INSTALLED IN ACCORDANCE WITH THE ABOVE ADVICE WILL NOT BE COVERED BY THE RHEEM WARRANTY.

38

Page 37 Page 39
Image 38
Page 37 Page 39
Contents Owners Guide Installation Instructions Patents Contents About Your Water Heater Model TypeHotter Water Increases the Risk of Scald Injury To Turn OFF the Water HeaterHOW Long will the Water Heater LAST? To Turn on the Water HeaterDoes the Water Quality Affect the Water HEATER? Anode Protection Flushing the Solar Collectors Freeze ProtectionRegular Care Temperature and Pressure Relief ValveSafety Expansion Control ValveElectric Boosting HOW Your Water Heater WorksMains Pressure Single Element Models Twin Element ModelsContinuous Tariff Connection Manual ON/OFF SwitchManual Controls ONE Shot Control Switch Going on HolidaysSave a Service Call Not Enough HOT Water or no HOT WaterWater not HOT Enough Continuous dribble Temperature and Pressure Relief Valve RunningNormal Operation Steady flows for long period often at nightCollector Glass High Electricity BillsElectricity Tariffs Installation Solar Storage Tank Tank Water Supply Safe TrayMax. mains supply pressure HOT Water DeliverySaddling Pipe Work Reducing Heat LossesAnode Types Booster Heating UnitCold Water Inlet Assembly of Cold Water Supply and Solar Pipe ConnectionsHOT Water Outlet Relief ValveRheemglas Indoor Location Outdoor Location Installation Solar Control Unit Solar Conversion of a Rheem Electric Water HeaterSolar Storage Tank with Solar Control Unit Installation of Solar Collectors Supplied in Solar Loline Conversion KITLatitude of Some Australian Cities Installation Solar CollectorsSolar Collector Location INLET/OUTLET Connections Connections PlumbingConnection Sizes Pipe SizesPipe Lengths Relief Valve Drain Bleed Valve DrainExpansion Control Valve Thermostat Setting Connections ElectricalManual Controls Bleeding the Solar Collectors CommissioningTo Fill and Turn on the Water Heater To Turn OFF the Water Heater Draining the Solar Collectors Draining the Water HeaterPage Water Supplies AnodeRheem Solar Water Heater Warranty Australia only Cylinder from date of installation Rheem will

Solar Loline Conversion Kit Electric Wter Heater specifications

The Rheem Solar Loline Conversion Kit for electric water heaters is a remarkable solution that integrates solar energy into water heating systems, facilitating a more sustainable and efficient way to heat water. This innovative kit is designed specifically to convert existing electric water heaters into solar-compatible units, enabling homeowners to harness the power of the sun for their hot water needs.

One of the main features of the Rheem Solar Loline Conversion Kit is its compatibility with various electric water heater models. This flexibility allows homeowners to enhance their existing systems without the need for complete replacement, making it a cost-effective choice for many. The kit includes all necessary components required for the installation, including a solar controller, a solar pump, and the required plumbing fittings, ensuring a seamless upgrade process.

This conversion kit utilizes advanced technologies to maximize energy efficiency. The solar controller optimizes the operation of the system by monitoring the temperature of the water in the storage tank and the solar collectors, ensuring that the water is heated when sufficient solar energy is available. This intelligent management helps reduce electricity consumption, leading to significant savings on energy bills.

In terms of characteristics, the Rheem Solar Loline Conversion Kit boasts high-quality construction and reliable performance. The durable components ensure a long lifespan and minimal maintenance, making it a wise investment for environmentally-conscious homeowners. The solar pump, designed for efficiency, enhances the movement of water between the solar collectors and the storage tank, ensuring optimal heat transfer and system performance.

Moreover, the kit promotes sustainability by reducing reliance on fossil fuels and decreasing carbon emissions. By utilizing solar energy for water heating, homeowners can significantly lower their environmental impact while enjoying the benefits of hot water on demand.

In conclusion, the Rheem Solar Loline Conversion Kit for electric water heaters presents an excellent opportunity for homeowners to embrace solar energy. With its compatibility, advanced technologies, and eco-friendly characteristics, this conversion kit stands as an ideal solution for those looking to enhance their water heating systems while contributing to a greener future. Whether for new installations or retrofitting existing systems, the Rheem Solar Loline Conversion Kit is designed to meet modern demands for efficiency and sustainability.
Top Page Image Contents