Installation Check List

A.Outdoor Water Heater Location

❑Outdoor water heaters must be installed outdoors.

❑Protected from freezing temperatures.

B.Indoor Water Heater Location

❑Close to area of vent termination.

❑Indoors and protected from freezing temperatures .

❑Proper clearance from combustible surfaces observed.

❑Sufficient fresh air supply for proper operation of water heater.

❑Air supply free of corrosive elements and flammable vapors.

❑Provisions made to protect area from water damage.

❑Sufficient room to service heater.

❑Combustible materials, such as clothing, cleaning materials, rags, etc. clear of the heater and vent piping.

❑Water heater is properly attached to the wall.

❑Water supply has sufficient pressure.

❑Air purged from water heater and piping.

❑Water connections tight and free of leaks

❑Water filter is clean and in place.

❑Materials used are as instructed in this manual.

❑Water pipes are insulated and protected from freezing.

❑Gas type matches rating plate.

❑Gas supply pressure is sufficient for the water heater.

❑Gas line equipped with shut-off valve, union and sediment trap.

❑Approved pipe joint compound used.

❑Soap and water solution used to check all connections and fittings for possible gas leak.

❑Gas Company inspected installation (if required).

❑Pressure Relief Valve properly installed and discharge line run to open drain

❑Discharge line protected from freezing.

❑Materials used are as instructed in the manual.

❑Vent connector(s) pitched downward to termination (¼" per foot of length minimum) See page 13.

❑Vent connector(s) securely fastened together with high temperature silicone (500°F) (260°C) and air- tight.

❑All vent runs are properly supported.

❑Vent terminal is properly installed.

❑Sufficient combustion air is available.

❑Maximum and minimum vent lengths are observed.

❑Voltage matches rating plate.

❑Water heater is properly grounded.

❑Supply cord and/or wiring meets all local codes.