AquaStar 125B NGS specifications Limited Warranty, General

Page 21

LIMITED WARRANTY

Aquastar

General

Aquastar water heaters are warranted by the Manufacturer (BOSCH) through BBT North America. BBT North America (BBTNA) will furnish a replacement heat exchanger and will furnish a replacement of any other part which fails in normal use and service within the applicable periods specified below, in accordance with the terms of this warranty. The BBTNA replacement will be warranted for the unexpired portion of the original warranty. This warranty will be valid only for water heaters in possession of the original purchaser as recorded on the warranty card.

The heat exchanger

If the heat exchanger fails within twelve (12) years after the original installation and operation BBTA will furnish a replacement heat exchanger. However, if the water heater is installed in other than a single family dwelling this heat exchanger warranty is limited to two (2) years from date of original installation and operation.

Exceptions

This warranty will not apply:

1.to defects or malfunctions resulting from failure to properly install, operate or maintain the unit in accordance with the printed instructions provided;

2.to damage or abuse, accident, neglect or freezing and other acts of nature;

3.to damage resulting from operation with either the flame sensor rod or overheat sensor removed;

4.to failure of the heat exchanger resulting from the operation of the water heater in a corrosive atmosphere or at water temperatures exceeding the maximum rating, or if the water heater is not supplied with potable water;

5.to defects or damage cause by any attachment or modification, including any energy-saving device.

All other parts

If any other part fails within two (2) years after original installation and operation, BBTNA will furnish a replacement part free of charge.

Shipping costs

In addition to supplying the replacement part(s), BBTNA will provide ground service delivery for these parts. Expedited or upgraded shipping will be charged to the customer.

Service labor costs

This warranty does not cover any labor costs associated with service, removal or re-installation of part(s). All such costs must be borne by the Purchaser. Additionally, this warranty does not cover any labor costs associated with service, removal or re-installation of the original water heater or a replaced water heater.

How to Make a Claim

Any claim for warranty parts should be made to your local dealer, distributor or to BTNA. If BBTNA, please contact the Technical Support Department:

BBT NORTH AMERICA 340 Mad River Park Waitsfield, VT 05673 Phone: 800-642-3111 www.boschhotwater.com

In most cases, the dealer or distributor will be able to promptly honor your claim and subsequently notify BBTNA. However, all replacements are made subject to validation by BBTNA of in-warranty coverage. The damaged or defective item must be made available in exchange for the replacement.

Miscellaneous

No one is authorized to make any other warranties on behalf of BBTNA. It is expressly understood that the replacement warranty of BBTNA shall be in lieu of any and all other warranties, express or implied, including warranties of merchantability or fitness for a particular use or purpose, and further that BBTNA shall not be liable for any loss or damage directly or indirectly arising from the use of the hot water heater, or for any consequential damages arising from such use (including damages from water leakage). BBTNA’s sole liability with respect to any defect shall be for the replacement of the defective part(s). Some states do not allow such limitations and exclusions, so the above may not apply to you.

This warranty gives specific legal rights. You may also have other rights which vary from state to state.

6 720 606 518

21

Image 21
Contents Table of Contents For Your SafetyFeatures Unpacking the Aquastar HeaterRequired Natural Gas Pressure at inlet tap Front View Side View Model 125BSTOP a Front B Back Sides Floor C Vent Diameter General Rules to Follow For Safe Operation Proper Location for Installing Your HeaterClearances Combustion AIR RequirementsAquastar 125 B S is design certified for mounting on a wall Mounting InstallationFigure a VentingFigure C 720 606 Masonry Chimneys6 Adaptor Used on High Altitude Vent Adaptor for High Altitude InstallationsFor LP GAS GAS Line Sizing For Natural GASMaximum Capacity of Semi-Rigid ColumnGAS Line Sizing Maximum Inlet GAS Flow Pressure SettingWater Connections Above 4.500 ft consult your local gas supplierOperating Instructions For Your Safety Read Before Lighting the PilotWhat to do if YOU Smell GAS To Turn OFF GAS to AppliancePilot burner with air screen/ pilot orifice Maintenance and ServicePilot Lights but Flame Goes OUT When Button is Released Pilot Light will not LightAir in the Gas Line Gas pressure too low Burners do not Ignite When HOT Water is Turned onWater is TOO HOT Water is not HOT EnoughUnbalanced pressure in waterlines HOT Water Temperature Fluctuates / Unit DeactivatedDiagram of AquaStar 125 BS Interior Components Diagram and Parts List Interior Components Diagram Parts List 125BS Flow chart of Aquastar 125 BS General Limited Warranty720 606 720 606 BBT North AMERICA, Waitsfield, VT all rights reserved Bosch Group