SETTING CONTACT
REVERSEFUNCTION
NOTE
Limit Switch and ForceAdjustments must be completed before checking the contact reversefunction.
AOpen garage door using Wall Console.
B Lay a 2" x 4" board flat in center of doorway (Figure 10).
CClose door using Wall Console.
DCheck that door stops and reverses within 2 seconds after it contacts board:
•If door does not reverse, decrease Close Force until door reverses (Figure 9).
•If door still does not reverse, move Limit Switch toward door.
ECheck
•If beam is blocked, door will not close.
Figure 10 F
Checking _J
Contact2" x 4" board
NOTE
The door must contact the 2" x 4" board before the
Carriage activates the Close Limit Switch. If not, readjust the Close Limit Switch.
ACCESSORIES
PROGRAMMING THE
REMOTE CONTROL
ATo program one Button of a Remote Control (Figure 11):
•Locate Learn Button and Learn Indicator Light near Terminal Block on Power Head (Figure 12).
•Press and release Learn Button. Red Learn Indicator Light will blink 2 times per second.
•Press Remote Control Button once within 30 seconds. Red Learn Indicator Light will stay lit.
•Press Remote Control Button again. Red Learn Indicator Light will go out, indicating that memory is stored.
•Press again to Activate Unit.
BProgram each additional Remote using step A above.
To Erase All Remotes from Power Head Memory
APress and hold Learn Button on Power Head for 10 seconds or until Learn Indicator Light goes out. Memory is erased:
•Program Remotes again as needed.
To Replace Remote Control Battery
AFOR NON-FLASHLIGHTMODELS
•Pop off the back of the transmitter.
-Use coin, pen, screwdriver or any similar device.
-Replace old Battery with new coin type battery. o Replace back of remote.
BFOR FLASHLIGHT MODELS
•Slide open battery cover.
-Replace old Battery with new AAA battery.
o Replace battery cover.
AWARNING
Amoving garagedoor maycauseserious njury or death.
Do not allow children to play with the RemoteControls,
Ifthe SafetyReversedoesnot work properly:
"Closethe door anddisconnectthe Openerusingthe EmergencyReleaseCord.
,Do not usethe door Opener,RemoteControls,or WirelessKeypad.
•Referto the door anddoor 0 penerOwner'sManuals beforeattempting any repairs.
Remote Control Operation
APress Button on Remote Control. Garage door will move.
BPress Button again. Garage door will stop:
•The door automatically stops at the end of the open or close cycle.
Press Button again. Garage door will reverse.
Figure 1 1
DThere are several additional varieties of remote controls available from your local dealer, some equipped with
a flashlight.
_b
©
....@(h | LEARN | |
|
| |
CLOSE@ | MOREFORCE | INDICATOR |
LOCATED | LIGHT | |
|
| |
UNDERTHE | LEARN | |
LIGHT COVER | © | CODE |
| BUTTON | |
|
| |
Figure 12 Learn Code Button and Indicator Light.
(Located Lower Right Corner).
NOTE
eEach Remote Control must be programmed separately.
•The Remote Controls will not close the garage with malfunctioning
•Program Remote Controls, while at least 24" from Antenna Wire.
•If the red Learn Indicator Light blinks rapidly, programming stopped. Restart programming.
•Each Button on a
•A maximum of seven Remote Controls or Wireless
Keypads can be stored into the Receiver at one
time. If a Remote Control becomes lost, or if you want to delete a Remote Control or Wireless
Keypad, see "To EraseAll Receiver Memory."
8 | For Help, call |