SCHEDULED MAINTENANCE
AMonthly:
oDoor springs and door hardware:
-Oil door roller, bearings, and hinges using silicone lubricant or light oil.
Reattach Carriage Assembly to Rail Assembly:
a.Pull the Emergency Release Knobtoward Power Head.
b.Close door.
Contact Reverse Test,
-Perform Adjustment Step 2 on page 8.
A WARNIN J
AWARNING
Ifthe door fails to reverse on contact with the board, | ||||
are broken, Contact a Genie Fact0ry Authorized Dealer for | ||||
adjust the Close Force Control as specified in Set Limit | ||||
service or call Customer Service at 1,800,35'GENIE. | ! | |||
Switches and Force Controls on page 9. If the Opener still | ||||
• Balance Door. |
| fails, contact a Genie Factory Authorized Dealer for service | ||
- | Close door. |
| or call Customer Service at | |
|
| |||
- ReleaseCarriage Assembly from Rail Assembly by pulling | FCC AND IC CERTIFIED | |||
| down on Emergency Release Knob. |
| ||
|
|
| ||
- Raisedoor manually |
| |||
| that position. See Check Step 2 on page 4. |
| All devices comply with Part 15 of the FCCRules. | |
| NOTE |
| ||
|
| Operation is subject to the following two conditions: (1) | ||
When the door is |
| this device may not cause harmful interference, and (2) | ||
| this device must accept any interference received, includ- | |||
should | stay open. Slight movement isacceptable. | If | ||
ing interference that may cause undesired operation. | ||||
the door moves too much, contact a Genie Factory |
|
Authorized Dealer for service or call Customer Service at | B As Needed: |
1=800=35=GENIE. | • Replace Light Bulb |
|
TROUBLESHOOTING GUIDE
Safe=T=Beam ® System Self=Diagnostic Troubleshooting
Source (Red LED) | Sensor (Green LED) |
ONON
OFFOFF
OFFON
2 BLINKS, Pause
(Repeat)ON
Possible Problem
Normal operation
o Power Head not powered
o Wiring from Power Head bad
o Wiring to Source missing or bad o Power has been interrupted
o Beam not aligned o Beam obstructed o Sensor defective
Solution
None required
. Check breakers, fuses, plugs
. Check wiring for obvious shorts
. Check wiring
. Remove power and reapply
. Check Source, Sensor alignment
. Check for obstruction
. Contact Customer Service
2 BLINKS, Pause | OFF | o Wire to Sensor | missing or bad | ||
(Repeat) | o Sensor | defective |
| ||
|
| ||||
3 BLINKS, Pause |
| o Sensor | receiving | interference | |
(Repeat) |
|
|
|
|
|
| ON |
|
|
|
|
4 BLINKS, Pause | ON | . | Source | not sending pulses | |
(Repeat) | . | Source | defective |
| |
|
| ||||
o Check wiring
o Contact Customer Service
o Determine source of interference
o Check for sunlight or another opener on nearby door
. Contact Customer Service
o Contact Customer Service
. Contact Customer Service
10 | For Help, call |