Solution 4: Uninstall and reinstall the product

Solution 5: Uninstall and reinstall the HP Photosmart Software

Solution 1: Reset the product

Solution: Turn off the product and reset it by disconnecting the power cord. Wait 60 seconds, and then plug in the power cord. Turn on the product.

Cause: You needed to reset the product.

If this did not solve the issue, try the next solution.

Solution 2: Check the power cord and USB cable

Solution: Make sure that the power cord and USB cable are properly attached and plugged in. Also, make sure that the product is turned on.

To check the power supply

1.Make sure the power cord is firmly connected to both the product and the power adaptor. Plug the power cord into a power outlet, surge protector, or power strip.

Troubleshooting

1Power connection

2Power cord and adaptor

3Power outlet

2.Make sure the product is turned on.

3.If the product is not receiving electrical power, connect it to another power outlet.

4.Turn off the product and reset it by disconnecting the power cord.

5.Wait 5 seconds, and plug in the power cord.

6.Turn on the product.

7.Try to scan again.

Errors 175

Page 178
Image 178
HP C4435, C4485, C4472, C4440 manual Troubleshooting