Product might not be correctly installed

Try the following solutions to resolve the issue. Solutions are listed in order, with the most likely solution first. If the first solution does not solve the problem, continue trying the remaining solutions until the issue is resolved.

Solution 1: Reset the product

Solution 2: Check the power cord and USB cable

Solution 3: Restart the computer

Solution 4: Uninstall and reinstall the product

Solution 5: Uninstall and reinstall the HP Photosmart Software

Solution 1: Reset the product

Solution: Turn off the product and reset it by disconnecting the power cord. Wait 60 seconds, and then plug in the power cord. Turn on the product.

Cause: The product had to be reset.

If this did not solve the issue, try the next solution.

Solution 2: Check the power cord and USB cable

Solution: Make sure that the power cord and USB cable are properly attached and plugged in. Also, make sure that the product is turned on.

To check the power supply

1.Make sure the power cord is firmly connected to both the product and the power adaptor. Plug the power cord into a power outlet, surge protector, or power strip.

1Power connection

2Power cord and adaptor

3Power outlet

Troubleshooting

Errors 171

Page 174
Image 174
HP C4435, C4485, C4472, C4440 manual Product might not be correctly installed, Solution 2 Check the power cord and USB cable