Chamberlain 3245M 1/3 HP, 3255-2M 1/2 HP Fasten the Door Bracket, Sectional Doors, Wood Doors

Page 19

INSTALLATION STEP 11

Fasten the Door Bracket

Follow instructions which apply to your door type as illustrated below or on the following page.

A horizontal reinforcement brace should be long enough to be secured to two or three vertical supports. A vertical reinforcement brace should cover the height of the top panel.

Figure 1 shows one piece of angle iron as the horizontal brace. For the vertical brace, 2 pieces of angle iron are used to create a U-shaped support. The best solution is to check with your garage door manufacturer for an opener installation door reinforcement kit.

Fiberglass, aluminum or lightweight steel garage doors WILL REQUIRE reinforcement BEFORE installation of door bracket. Contact your door manufacturer for reinforcement kit.

Header

Bracket

NOTE: Many door reinforcement kits provide for direct attachment of the clevis pin and door arm. In this case you will not need the door bracket; proceed to Step 12.

SECTIONAL DOORS

1. Center the door bracket on the previously marked

vertical centerline used for the header bracket

installation. Note correct UP placement, as stamped

inside the bracket.

Door

Bracket

Location

Vertical

Centerline

HORIZONTAL AND VERTICAL REINFORCEMENT IS NEEDED FOR LIGHTWEIGHT GARAGE DOORS (FIBERGLASS, ALUMINUM, STEEL, DOORS WITH GLASS PANEL, ETC). (NOT PROVIDED)

2. Position the top edge of the bracket 2"-4" (5-10 cm)

below the top edge of the door, OR directly below any

Figure 1

structural support across the top of the door.

3. Mark, drill holes and install as follows, depending on

your door’s construction:

Metal or light weight doors using a vertical angle iron brace between the door panel support and the door bracket:

•Drill 3/16" fastening holes. Secure the door bracket using the two 1/4"-14x5/8" self-threading screws (Figure 2A).

•Alternately, use two 5/16" bolts, lock washers and nuts (not provided) (Figure 2B).

Metal, insulated or light weight factory reinforced doors:

• Drill 3/16" fastening holes. Secure the door bracket

Vertical

Reinforcement

Vertical

Centerline

of Garage Door

UP

Door

Bracket

Self-Threading

Screw 1/4"-14x5/8"

Figure 2A

Vertical

Reinforcement

 

Vertical

 

Centerline

 

of Garage Door

Bolt

 

5/16"-18x2"

 

(Not Provided)

 

 

UP

Door

 

Bracket

 

Lock Washer

5/16"

Nut

 

 

5/16"-18

Figure 2B

using the self-threading screws (Figure 3).

Wood Doors:

•Use top and bottom or side to side door bracket holes. Drill 5/16" holes through the door and secure bracket with 5/16"x2" carriage bolts, lock washers and nuts (not provided) (Figure 4).

NOTE: The 1/4"-14x5/8"

HARDWARE

self-threading screws are not

SHOWN

intended for use on wood doors.

ACTUAL SIZE

 

Self-Threading

 

Screw

 

1/4"-14x5/8"

Vertical

Centerline

of Garage Door

UP

Self-Threading Screw 1/4"-14x5/8"

Figure 3

Inside Edge of Door or

Bolt Reinforcement Board 5/16"x2"

(Not

Provided)

UP

Vertical

Centerline

of Garage

Door

Figure 4

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents For Residential Use Only Garage Door OpenerIntroduction Table of ContentsOne-Piece Door Preparing your garage doorTools needed Sectional DoorONE-PIECE Door with Track Sectional Door InstallationPlanning ONE-PIECE Door Without TrackCarton Inventory Installation HardwareAttach the Rail to the Motor Unit Assembly StepBolt previously removed from motor unit Tighten the Chain InstallationDetermine the Header Bracket Location Installation StepWall Header Bracket Installation Install the Header BracketCeiling Header Bracket Installation Attach the Rail to the Header Bracket Sectional Door or ONE-PIECE Door with Track Position the OpenerHang the Opener Standard installation only Run bell wire up wall Install the Door ControlAttach the Emergency Release Rope and Handle Install the LightElectrical Requirements Important Information about Safety Reversing Sensor Install The Protector SystemFacing the door from inside the garage Floor installation Figure Installing the BracketsGarage door track installation preferred Wall installationTroubleshooting the Safety Reversing Mounting and Wiring the Safety Reversing SensorsAligning the Safety Reversing Sensors Wood Doors Metal, insulated or light weight factory reinforced doorsFasten the Door Bracket Sectional DoorsONE-PIECE Doors Sectional Doors only Connect Door Arm to TrolleyConnect the door arm to the trolley Adjustment procedures, FigureALL ONE-PIECE Doors Assemble the door arm, FigureIf the door does not close completely Adjustment StepAdjust the UP and Down Travel Limits If door does not open at least 5 feet 1.5 mTest the UP open force Adjust the ForceHOW and When to Adjust the Forces Test the Down close forceTest The Protector System Test the Safety Reversal SystemAdjust Important Safety CheckOperation Using Your Garage Door OpenerActivate your opener with any of the following Lock feature Light featureMULTI-FUNCTION Door Control Once a Year Care of Your OpenerOnce a Month Twice a YearHaving a PROBLEM? Symptom Motor unit doesn’t operate Safety reversing sensors wire open broken or disconnectedDoor control or wire shorted Symptom LED is not lit on door controlTo Erase All Codes From Motor Unit Memory To Add or Reprogram a Hand-held Remote ControlUsing the Learn Button Using the Door Control ProgrammingTo change an existing, known PIN To Add, Reprogram or Change a Keyless Entry PINTo set a temporary PIN Rail Assembly Parts Repair PartsInstallation Parts Complete with Spring washer Motor Unit Assembly PartsComplete with Logic board Accessories Liftmaster Service is On Call

3255M 1/2 HP, 3245M 1/3 HP, 3255-2M 1/2 HP specifications

The Chamberlain 3255-2M, 3245M, and 3255M garage door openers stand out in the market for their reliability and superior performance. Each model offers a unique combination of power and features, catering to different needs and preferences.

The Chamberlain 3255-2M is a robust 1/2 HP opener designed for heavy residential garage doors. Its powerful motor ensures smooth and efficient operation, making it ideal for doors weighing up to 7 feet high. This model incorporates the latest in opening technology, including a durable chain drive mechanism that provides strength and longevity. One of its significant features is the incorporated MyQ technology, enabling users to control their garage door remotely through a smartphone app. This innovative feature brings convenience and peace of mind, as homeowners can check the status of the door from anywhere.

Another excellent choice is the Chamberlain 3245M, a 1/3 HP model that offers a balance of performance and affordability. It is suitable for lighter doors, providing consistent and reliable opening and closing. The 3245M model also boasts a protective cover that enhances its durability against the elements. It operates quietly thanks to its direct drive system, making it an excellent option for garages attached to living spaces. Like the 3255-2M, this model is also equipped with MyQ technology, allowing users to monitor and control their garage door from their smartphones seamlessly.

Finally, the Chamberlain 3255M, another 1/2 HP opener, offers similar features to the 3255-2M but with a focus on belt drive technology. This model is built for quieter performance, making it ideal for homes where noise is a concern. The belt drive reduces vibrations and sound, ensuring a smoother user experience. This model also comes with a battery backup system, which provides added security during power outages.

All these models emphasize safety and security, featuring auto-reverse functionality that senses obstacles and prevents the door from closing on them. The Chamberlain garage door openers are also equipped with a rolling code technology that changes the access code each time the remote is used, enhancing security against unauthorized access.

In summary, the Chamberlain 3255-2M, 3245M, and 3255M garage door openers cater to a variety of needs with their powerful motors, innovative technologies, and user-friendly features. Their reliability and performance make them an excellent investment for any homeowner.
Top Page Image Contents