Chamberlain 3255M 1/2 HP Install the Light, Attach the Emergency Release Rope and Handle

Page 14

INSTALLATION STEP 7

Install the Light

Press the release tabs on both sides of lens. Gently rotate lens back and downward until the lens hinge is in the fully open position. Do not remove the lens.

Install a 100 watt maximum light bulb in each socket. Light bulb size should be A19, standard neck only. The lights will turn ON and remain lit for approximately 4-1/2 minutes when power is connected. Then the lights will turn OFF.

Reverse the procedure to close the lens.

Use A19, standard neck garage door opener bulbs for replacement.

NOTE: Use only standard light bulbs. The use of short neck or speciality light bulbs may overheat the endpanel or light socket.

To prevent possible OVERHEATING of the endpanel or light socket:

DO NOT use short neck or specialty light bulbs.

DO NOT use halogen bulbs. Use ONLY incandescent.

To prevent damage to the opener:

DO NOT use bulbs larger than 100W.

ONLY use A19 size bulbs.

100 Watt (Max)

Standard Light Bulb

Release Tab

Lens Hinge

INSTALLATION STEP 8

Attach the Emergency Release Rope and Handle

Thread one end of the rope through the hole in the top of the red handle so “NOTICE” reads right side up as shown. Secure with an overhand knot at least 1"

(2.5 cm) from the end of the rope to prevent slipping.

Thread the other end of the rope through the hole in the release arm of the outer trolley.

Adjust rope length so the handle is 6 feet (1.83 m) above the floor. Ensure that the rope and handle clear the tops of all vehicles to avoid entanglement. Secure with an overhand knot.

NOTE: If it is necessary to cut the rope, heat seal the cut end with a match or lighter to prevent unraveling.

To prevent possible SERIOUS INJURY or DEATH from a falling garage door:

If possible, use emergency release handle to disengage trolley ONLY when garage door is CLOSED. Weak or broken springs or unbalanced door could result in an open door falling rapidly and/or unexpectedly.

NEVER use emergency release handle unless garage doorway is clear of persons and obstructions.

NEVER use handle to pull door open or closed. If rope knot becomes untied, you could fall.

Overhand Knot

Trolley

Trolley

Release Arm

 

Rope

Emergency Release Handle

14

Image 14
Contents Garage Door Opener For Residential Use OnlyTable of Contents IntroductionSectional Door Preparing your garage doorTools needed One-Piece DoorONE-PIECE Door Without Track Sectional Door InstallationPlanning ONE-PIECE Door with TrackInstallation Hardware Carton InventoryBolt previously removed from motor unit Assembly StepAttach the Rail to the Motor Unit Installation Tighten the ChainInstallation Step Determine the Header Bracket LocationCeiling Header Bracket Installation Install the Header BracketWall Header Bracket Installation Attach the Rail to the Header Bracket Position the Opener Sectional Door or ONE-PIECE Door with TrackHang the Opener Install the Door Control Standard installation only Run bell wire up wallInstall the Light Attach the Emergency Release Rope and HandleElectrical Requirements Facing the door from inside the garage Install The Protector SystemImportant Information about Safety Reversing Sensor Wall installation Installing the BracketsGarage door track installation preferred Floor installation FigureAligning the Safety Reversing Sensors Mounting and Wiring the Safety Reversing SensorsTroubleshooting the Safety Reversing Sectional Doors Metal, insulated or light weight factory reinforced doorsFasten the Door Bracket Wood DoorsONE-PIECE Doors Connect Door Arm to Trolley Sectional Doors onlyAssemble the door arm, Figure Adjustment procedures, FigureALL ONE-PIECE Doors Connect the door arm to the trolleyIf door does not open at least 5 feet 1.5 m Adjustment StepAdjust the UP and Down Travel Limits If the door does not close completelyTest the Down close force Adjust the ForceHOW and When to Adjust the Forces Test the UP open forceImportant Safety Check Test the Safety Reversal SystemAdjust Test The Protector SystemActivate your opener with any of the following Using Your Garage Door OpenerOperation MULTI-FUNCTION Door Control Light featureLock feature Twice a Year Care of Your OpenerOnce a Month Once a YearHaving a PROBLEM? Symptom LED is not lit on door control Safety reversing sensors wire open broken or disconnectedDoor control or wire shorted Symptom Motor unit doesn’t operateProgramming To Add or Reprogram a Hand-held Remote ControlUsing the Learn Button Using the Door Control To Erase All Codes From Motor Unit MemoryTo set a temporary PIN To Add, Reprogram or Change a Keyless Entry PINTo change an existing, known PIN Installation Parts Repair PartsRail Assembly Parts Complete with Logic board Motor Unit Assembly PartsComplete with Spring washer Accessories Liftmaster Service is On Call

3255M 1/2 HP, 3245M 1/3 HP, 3255-2M 1/2 HP specifications

The Chamberlain 3255-2M, 3245M, and 3255M garage door openers stand out in the market for their reliability and superior performance. Each model offers a unique combination of power and features, catering to different needs and preferences.

The Chamberlain 3255-2M is a robust 1/2 HP opener designed for heavy residential garage doors. Its powerful motor ensures smooth and efficient operation, making it ideal for doors weighing up to 7 feet high. This model incorporates the latest in opening technology, including a durable chain drive mechanism that provides strength and longevity. One of its significant features is the incorporated MyQ technology, enabling users to control their garage door remotely through a smartphone app. This innovative feature brings convenience and peace of mind, as homeowners can check the status of the door from anywhere.

Another excellent choice is the Chamberlain 3245M, a 1/3 HP model that offers a balance of performance and affordability. It is suitable for lighter doors, providing consistent and reliable opening and closing. The 3245M model also boasts a protective cover that enhances its durability against the elements. It operates quietly thanks to its direct drive system, making it an excellent option for garages attached to living spaces. Like the 3255-2M, this model is also equipped with MyQ technology, allowing users to monitor and control their garage door from their smartphones seamlessly.

Finally, the Chamberlain 3255M, another 1/2 HP opener, offers similar features to the 3255-2M but with a focus on belt drive technology. This model is built for quieter performance, making it ideal for homes where noise is a concern. The belt drive reduces vibrations and sound, ensuring a smoother user experience. This model also comes with a battery backup system, which provides added security during power outages.

All these models emphasize safety and security, featuring auto-reverse functionality that senses obstacles and prevents the door from closing on them. The Chamberlain garage door openers are also equipped with a rolling code technology that changes the access code each time the remote is used, enhancing security against unauthorized access.

In summary, the Chamberlain 3255-2M, 3245M, and 3255M garage door openers cater to a variety of needs with their powerful motors, innovative technologies, and user-friendly features. Their reliability and performance make them an excellent investment for any homeowner.