Instructions for the Installer
8.FITTING THE APPLIANCE
8.1Fitting the appliance in the top
This appliance is in class 3. The procedures required below must be carried out by a skilled builder and/or joiner.
The hob can be installed on various materials, including masonry, metal, solid wood and wood finished with plastic laminates, provided the material is
8.1.1 Installing to a traditional
Make a hole in the cabinet top with the dimensions shown here, maintaining a distance of at least 110 mm from the rear edge. This appliance may be installed against walls higher than the worktop surface, provided the distance "X" shown here is maintained, in order to prevent damage due to overheating. Make sure that there is at least 750 mm between the hob burners and any shelving placed vertically above them.
1) 
CAUTION: IF YOU ARE INSTALLING A HOB WITH FISH BURNER, THE DISTANCE "X" FROM THE REAR WALL INCREASES FROM 110 mm TO 300 mm.
Fit the insulating gasket provided carefully around the outside edge of the hole made in the top, pressing it down with your hands so that its entire surface fits snugly. Now place the 12 brackets supplied to secure the top to the supporting structure. See point "6.2 Securing the appliance to the cabinet"
29
