Instructions for the Installer
8.3Electrical connection
Check that the power supply voltage and size are as specified on the nameplate below the appliance carter.
The nameplate must never be removed.
The appliance must be connected to earth in compliance with electrical system safety regulations.
If a permanent connection is used, the appliance's power supply line must be fitted with an omnipolar breaking device with contact gap of at least
3mm, located in an easily accessible position close to the appliance itself.
If a socket and plug connection is used, check that they are of the same type. Do not use reducers, adapters or junctions since they may cause overheating or burns.
Operation at
x 1.5 mm2 for electric hobs and a cable of 3 x 0.75 mm2 for gas hobs)
The earth wire
The manufacturer declines all responsibility for injury or damage caused by failure to comply with the above regulations or deriving from tampering with even just one part of the appliance.
33