Chamberlain 3245M 1/3 HP, 3255-2M 1/2 HP, 3255M 1/2 HP Attach the Rail to the Header Bracket

Page 10

Header Wall

Header Bracket

Chain Pulley

Bracket

INSTALLATION STEP 3

Attach the Rail to the Header Bracket

•Position the opener on the garage floor below the header bracket. Use packing material as a protective base. NOTE: If the door spring is in the way you’ll need help. Have someone hold the opener securely on a temporary support to allow the rail to clear the spring.

•Position the rail bracket against the header bracket.

•Align the bracket holes and join with a clevis pin as shown.

•Insert a ring fastener to secure.

	Rail	Ring Fastener
	Rail	Header Bracket
		Header Bracket
		Clevis Pin
		5/16"x2-3/4"
		Chain
		Pulley
		Bracket
		Rail
	Garage
	Door
		Temporary
		Support

HARDWARE SHOWN ACTUAL SIZE

Clevis Pin
5/16"x2-3/4"	Ring Fastener

Image 10

Contents Garage Door Opener For Residential Use OnlyTable of Contents IntroductionSectional Door Preparing your garage doorTools needed One-Piece DoorONE-PIECE Door Without Track Sectional Door InstallationPlanning ONE-PIECE Door with TrackInstallation Hardware Carton InventoryAttach the Rail to the Motor Unit Assembly StepBolt previously removed from motor unit Installation Tighten the ChainInstallation Step Determine the Header Bracket LocationWall Header Bracket Installation Install the Header BracketCeiling Header Bracket Installation Attach the Rail to the Header Bracket Position the Opener Sectional Door or ONE-PIECE Door with TrackHang the Opener Install the Door Control Standard installation only Run bell wire up wallInstall the Light Attach the Emergency Release Rope and HandleElectrical Requirements Important Information about Safety Reversing Sensor Install The Protector SystemFacing the door from inside the garage Wall installation Installing the BracketsGarage door track installation preferred Floor installation FigureTroubleshooting the Safety Reversing Mounting and Wiring the Safety Reversing SensorsAligning the Safety Reversing Sensors Sectional Doors Metal, insulated or light weight factory reinforced doorsFasten the Door Bracket Wood DoorsONE-PIECE Doors Connect Door Arm to Trolley Sectional Doors onlyAssemble the door arm, Figure Adjustment procedures, FigureALL ONE-PIECE Doors Connect the door arm to the trolleyIf door does not open at least 5 feet 1.5 m Adjustment StepAdjust the UP and Down Travel Limits If the door does not close completelyTest the Down close force Adjust the ForceHOW and When to Adjust the Forces Test the UP open forceImportant Safety Check Test the Safety Reversal SystemAdjust Test The Protector SystemOperation Using Your Garage Door OpenerActivate your opener with any of the following Lock feature Light featureMULTI-FUNCTION Door Control Twice a Year Care of Your OpenerOnce a Month Once a YearHaving a PROBLEM? Symptom LED is not lit on door control Safety reversing sensors wire open broken or disconnectedDoor control or wire shorted Symptom Motor unit doesn’t operateProgramming To Add or Reprogram a Hand-held Remote ControlUsing the Learn Button Using the Door Control To Erase All Codes From Motor Unit MemoryTo change an existing, known PIN To Add, Reprogram or Change a Keyless Entry PINTo set a temporary PIN Rail Assembly Parts Repair PartsInstallation Parts Complete with Spring washer Motor Unit Assembly PartsComplete with Logic board Accessories Liftmaster Service is On Call