Rear Panel Connections
AM Antenna: Connect the AM loop anten- na supplied with the receiver to these terminals. If an external AM antenna is used, make connections to the AM and GND terminals in accordance with the instructions supplied with the antenna.
FM Antenna: Connect an indoor or external FM antenna to this terminal.
Phono Ground: Connect the ground wire from a turntable to this terminal to reduce sys- tem hum.
Remote IR In: If the HK 3380’s front panel IR sensor is blocked due to cabinet doors or other obstructions, an external IR sensor may be used.
Connect the output of the sensor to this jack.
Remote IR Out: This connection permits the IR sensor in the receiver to serve other remote controlled devices. Connect this jack to the “IR IN” jack on Harman Kardon or other compatible equipment.
Phono Inputs: Connect the outputs of your turntable or tone arm to these jacks. Note that only Moving Magnet (MM) type cartridges may be used.
CD Inputs: Connect these jacks to the out- put of a compact disc player or CD changer.
Video 1 Audio/Video Play/In: Connect these jacks to the PLAY/OUT jacks of an audio or video device, such as a VCR or DVD player. In order to view the video signal of a video device connected to this input, remember to connect the
Video Monitor Output | to the video input |
of your TV or video display. |
|
Tape Monitor Play/In: Connect these jacks to the Play/Out jacks of an audio recorder.
Tape Monitor Record/Out: Connect these jacks to the Rec/In jacks of an audio recorder.
NOTE: When these jacks are connected to a
Video 1 Audio/Video Record/Out: Connect these jacks to the Rec/In jacks of an audio or video recorder.
Video 2 Audio/Video Inputs: Connect these jacks to the PLAY/OUT jacks of an audio or video device, such as a VCR or DVD player. In order to view the video signal of a video device connected to this input, remember to connect the Video Monitor Output to the video input of your TV or video display.
Main In: These jacks are the input to the HK 3380’s power amplifier. Unless an external power amplifier is used, the jumper pins should remain connected to the Preamp Out jacks .
Video 3 Audio/Video Inputs: Connect these jacks to the PLAY/OUT jacks of an audio or video device, such as a VCR or DVD player. In order to view the video signal of a video device connected to this input, remember to connect the Video Monitor Output to the video input of your TV or video display.
Preamp Out: These jacks provide an output for the left and right channels to an optional external amplifier. In normal operation, unless an external power amplifier is used, the jumper pins should remain connected to the Main In jacks .
Subwoofer Out: Connect these jacks to the
Speaker 1 Terminals: Connect these ter- minals to the appropriate terminals on your speakers.
Speaker 2 Terminals: Connect these ter- minals to the appropriate terminals on your speakers.
Switched AC Outlet: These outlets may be used to power
Power Cable: Connect the AC plug to a nonswitched AC wall output.
NOTE: The power consumption of the devices plugged into these outlets should not exceed 100 watts.
Video Monitor Output: Connect this jack
to the composite video input of your TV or video display device. Doing so will enable you to view the video signal of a properly connected video source device, when that source input is select- ed. When an
Video Monitor Output | will not transmit a |
video signal. |
|
REAR PANEL CONNECTIONS 7