Harman-Kardon HK 3380 owner manual Troubleshooting Guide, If the problem is, Make sure that

Page 16

Troubleshooting Guide

This unit is designed for trouble-free operation. Most problems users encounter are due to operating errors. If you have a problem, first check this list for a possible solution. If the problem persists, consult your authorized Harman Kardon Service Center.

If the problem is...

No lights appear when System Power 2 button is pressed

Make sure that the...

Unit is plugged into a live outlet.

No sound is heard	Unit has not been muted.
	Correct input function selector button has been pressed.
	Volume is turned up.
	Speakers have been turned on using the Speaker Selectors 67ü√.

No output from one or more channels	Cables are not defective: check/replace speaker cables.

Tuner sound has a large amount of interference, or	Antenna is properly connected.
the “Stereo” display is not illuminated, or	Antenna is properly located.
Tuner sound distorts and/or is noisy	Antenna is set in the proper direction.
	Antenna is adequate to receive the desired station.

Tuner is intermittent or continuously buzzing or hissing	Unit is away from fluorescent lights, TVs, motors and
	other electrical appliances.
Remote does not function correctly	Batteries are not weak, and replace them if necessary.
	Correct device page has been selected by pressing the Source Selector key ç.
	Remote sensor is not obstructed, and remote is pointing directly at sensor at an angle of
	no more than 30 degrees. Also, check for fluorescent lighting, which may be interfering
	with the IR transmission.
Cassette or CD sounds distorted	Cassette deck or CD player has not been plugged into the Phono input.
	(Only use the outputs of a turntable or tonearm with the Phono input.)

Turntable sounds distorted	Turntable has been plugged into the Phono Input ,
	as the other inputs are not compatable with turntable signal levels.

No video image	Video source unit’s video ouput is properly connected, the source is turned on and the correct
	video input on the HK 3380 has been selected.
	Video Monitor Output	is connected to a TV or video display, and that the TV is turned
	on and the proper input on the TV has been selected

16TROUBLESHOOTING GUIDE

Image 16

Contents HK 3380 Stereo Receiver Table of Contents Declaration of ConformityIntroduction Important InformationFront Panel Controls Output terminalsInputs FM Antenna Tape Monitor Record/Out AM Antenna Tape Monitor Play/InPhono Ground Video 1 Audio/Video Record/Out Video signal Rear Panel ConnectionsVideo Monitor Output Video Monitor Output Connect this jackRemote Control Functions ∂ and Tuning Up/Down ü buttons For more information on RDS tuningInstallation and Connections Audio and Speaker ConnectionsAudio Equipment Connections Aux jacks . Video 2 and Video Audio/Video inputs Or VideoSystem and Power Connections Operation Basic OperationSource Selection Tuner OperationRDS Operation Processor Reset Memory BackupTape Recording Using the Remote Control Input source selection on the HKSkip to another device to be controled Affected keys for these devicesIf the problem is Troubleshooting GuideMake sure that Technical Specifications Power ConsumptionDimension Max @ 1W +0dB, -3dBHarman Consumer International