Harman-Kardon AVR80 owner manual Continue to program any additional

AVR80 manual 11/01/98 13:01 Side 14

ENGLISH

Remote Control Programming & Operation

14

Another group of keys may only be programmed with one remote code. The code contained in these keys remains the same regardless of the source selection.

WARNING: These keys transmit codes that are vital to the operation of the product. It is not recommended that they be programmed with alternative codes, as it may then be impossible to operate certain functions of the receiver.

THX

Aux

Cursor Up Ú

Pro Logic

Delay

Cursor Down Û

Dolby 3 Stereo

Memo

Cursor Right Ý

Movie

Screen Display

Cursor Left Ü

Matrix

Panel Display

Select

Hall

Speaker

Main Volume Up Ú

Stereo

Test Noise

Main Volume Down Û

Mono

Adjust

Mute

RDS PTY

RDS AF

To program the remote, you need the remote of the device, whose functions shall be programmed. Note that it is not necessary to program all keys, only those

that are required to operate the subject device. Keys not programmed will retain the codes preprogrammed at the factory.

1.Slide Use/Learn aswitch at the top left corner of the remote to the right so that it is next to Learn.

2.If one of the multi-function buttons is being programmed press the source button (i.e. CD, VCR, etc.) you wish to have this function associated with. If you are programming a single function key, proceed to the next step.

3.Press the button on the remote that is to be programmed. Note that the Learning yLED will illuminate.

4.Place the remote head to head with the remote control whose function is being learned. The two remotes should be no more than 8 inches apart.

5.Press and hold the button on the transmitting remote corresponding to the function to be memorized until the Learning LED starts to blink. When the LED goes out, release the button on the transmitting remote. The function code has been successfully captured.

NOTE: If both LEDs flash during a programming operation, it indicates that the remote’s memory is full or that the remote codes from the transmitting remote are not compatible with the unit’s signal format.

6.Continue to program any additional

remote commands required using steps 2 through 5. When you have finished programming the remote, slide the Use/Learn switch to the left so that it is in the Use position.

Clearing the Remote Memory In normal operation, codes for a new device may be programmed “over” the codes that have been previously programmed into the remote. It is also possible to clear the memory for individual keys, or for the entire remote. When a memory position is cleared, the remote will return to the original factory preset command.

To clear the memory for a specific individual key location, put the Use/Learn switch in the Learn position. Press the Main Power Off b button and the button to be cleared at the same time. Both the Sending and Learning indicators will light momentarily. When the lights go out, the memory has been cleared of the user programmed code and returned to the factory preset. Return the Use/Learn

aswitch to the Use position when you are finished.

To clear the remote’s entire memory and return all keys to their factory preset commands first put the Use/Learn a switch in the Learn position. Then press the Main Power On button band confirm that the Learning indicator y has illuminated. While continuing to press the Power On button, press and hold the Power Off bbutton until the Learn indicator goes off for about 3 seconds. It will then blink twice. Then release the two buttons. This indicates that the memory has been cleared of any user programmed commands and that the original commands have been restored. Slide the Use/Learn switch back to the Use a position to return the remote to normal operation.