Sears 680.84973 manual Assembly, Lower Handle Tube Upper

DO NOT PLUG IN ELECTRIC CORD UNTIL BRUSHES OR OTHER ACCESORIES HAVE BEEN ATTACHED AND SWITCH HAS BEEN PLACED IN THE "OFF" POSITION.

HANDLE,

SWITCH BOX AND CORD

I. Place Lower handle tube (Fig. i) into handle tube socket "A" (Fig. 2). Fasten using bolt "B" and internally threaded nut "C" (Fig. 3) provided in the hardware package.

If the handle tube is difficult to assemble (tight), insert blade of screwdriver into sl.ot (Fig. 4) at rear of handle tube socket and twist screwdriver gently while inserting handle tube.

2. Place upper half handle tube (Fig. 1) over

tower half. Align holes and fasten with remaining

ASSEMBLY

INSTRUCTIONS

B_ _]_C

LOWER

HANDLE

TUBE

FIG. 2

UPPER

HANDLE

bolt "B" and internally threaded nut "C".

TUBE

C:_C

3. Attach switch box to rear of upper handle
tube. Place switch box tab (no hole) into
rectangular hole (Fig°	5). Position	box	against
handle tube. Fasten	using the	small	screw

provided in the hardware package. DO NOT OVERTIGHTEN.

4.The motor cord, which goes from the switch box to the bottom of the unit, is attached in two (2) locations behind the dispenser at top and bottom° The upper part of the motor cord is snapped into place alongside the upper cord hook on the dispenser top (Fig 6).

The lower part of the motor cord is snapped into place between the two tower cord hooks. They are located on the dispenser base (Fig. 7).

5.Attach lower plastic hose to rear of unit by

inserting the fitting on the end of hose into the hole located midway at rear of unit (Fig. 8).

6.The electric cord is wound around cord hooks as illustrated in (Fig. 9).

Note: At[ moving parts requiring lubrication

have been permanently lubricated at the factory.

_B

FIG. 1 FIG. 3

FIG, 4 FIG, 5

111

FIG. 6 FIG. 7

FIG. 8 FIG. 9