Assembly
You need: Phillips head screwdriver.
Attach handle to vacuum
1.Locate the vacuum handle and remove the screw packet taped to the base of the handle.
2.Stand the vacuum upright and slide the base of the handle firmly into the grooves at the top of the vacuum body.
3.Check to be sure the handle is fitted to the vacuum body. If there is a gap in front, continue to push firmly until the handle is flush.
4.Insert the screw provided from the screw packet into the existing hole. Tighten securely with a screwdriver.
Attach vacuum hose and tools | 1. | ||
1. | Line up tabs on the base of the Twist ‘n | ||
| |||
| Snap hose with the corresponding notches |
| |
| on the hose collar. Turn the hose to the |
| |
| right to lock into place. |
| |
2. | Grasp the Quick Reach Handle and slide |
| |
| the end of the hose into the hose wand |
| |
| base. Snap the hose into the upper hose |
| |
| clip on handle. |
| |
3. | Slide the extension wand and crevice tool |
| |
| together into storage clip. |
| |
4. | Snap the combination tool into the storage |
| |
| clip. |
| |
5. | Attach the TurboBrush Tool by lining up | 5. | |
| with base of holder in handle and push | ||
back to snap into place.
2.
4.
4.
3.
2.
5
w w w . b i s s e l l . c o m | 8 0 0 . 2 3 7 . 7 6 9 1 |