Bissell 28F4, 80E7 Operations, Handle position, Powerfoot height adjustment, Transporting cleaner

Page 6

Operations

Handle position

Press the handle release pedal with your foot to place your BISSELL Cleanview cyclonic bagless vacuum into one of three cleaning positions.

1.Upright- For storage and above floor cleaning with special tools.

2.Normal Cleaning- Press handle release pedal once. Use for most household floor cleaning tasks.

3.Low Cleaning- With the vacuum in normal cleaning position, press handle release pedal again. Use for reaching under low furniture such as tables, chairs and beds.

Powerfoot height adjustment

The powerfoot/rotating floor brush on your BISSELL Cleanview cyclonic bagless vacuum can be adjusted to clean several floor surfaces.

NOTE: For optimal cleaning performance, adjust to the lowest practical setting. If your cleaner is difficult to push, adjust to the next higher setting.

1.Place handle in upright position.

2.Turn height adjustment knob to desired setting.

Lowest Setting - For bare floors.

Medium Settings - For short and medium pile carpets.

Highest Setting - For plush pile carpets.

3.Place the handle into the normal cleaning position and the powerfoot will adjust to the setting chosen.

NOTE: You may also adjust the setting while in the normal cleaning position.

Transporting cleaner

1.To move your cleaner from room to room, put the handle in the upright position, tilt the cleaner back on its rear wheels and push forward.

2.The cleaner can also be moved by using the carrying handle on the back.

6 w w w . b i s s e l l . c o m

1

2

3

caution:

Before using your vacuum, make sure that the dirt container is in locked position and that all filters (inner circular, outer circular, pre-motor and post- motor) are in place. Do not operate your vacuum without these filters.

ATTENTION:

Some Berber carpets have a tendency to fuzz with wear. Repeated strokes in the same area may aggravate this condition. Consider setting your cleaner on a higher than normal setting for this type of carpet.

Tip:

Before cleaning under low furni- ture, check area first for objects that might harm the unit or block the vacuum hose.

Tip:

 

Your vacuum

 

features a Quick

 

Release cord

 

wrap. To remove

 

the power cord

 

quickly and eas-

 

ily, rotate the

 

upper cord wrap

 

towards the floor,

Carrying

and slip power

Handle

cord from upper

 

and lower

cord wraps.

Page 5 Page 7
Image 6
Page 5 Page 7
Contents CLEANview 80E7 and 28F4 SeriesThanks for buying a Bissell Cleanview Cyclonic Important Safety Instructions Reduce the risk of fire, electric shock, or injuryProduct view Assembly Attach handle to vacuumAttach vacuum hose and tools Lowest Setting For bare floors Powerfoot height adjustmentTransporting cleaner OperationsSpecial tools Power cordTurn power switch OFF Raise handle to upright positionFull Line Maintenance and careEmptying dirt container UnlockUnplug cleaner from electrical outlet Cleaning the inner & outer circular filtersCleaning the pre-motor filter Pre-Motor FilterReplacing the Hepa media post-motor filter Maintaining the TurboBrush toolMedia Post-Motor Filter Unplug cleaner from electrical outlet Brush Check rotating floor brush and drive beltReplace drive belt Clearing clog Troubleshooting Replacement parts Part Name203-1068 Extension Wand 203-1216 For spare parts and accessories WarrantyLimited One Year Warranty For UK inquiriesIf your Bissell product should require service Bissell consumer services
Top Page Image Contents