Bissell 80E7, 28F4 Cleaning the inner & outer circular filters, Cleaning the pre-motor filter

Page 9

Maintenance and care

Cleaning the inner & outer circular filters

1.Unplug cleaner from electrical outlet.

2.Remove the dirt container as described in the previous section. Grasp the filter cup located at the bottom of the dirt container and twist counterclockwise to unlock and remove.

3.Grasp the circular filters and pull straight up to remove.

4.Separate the outer foam and inner pleated circular filters. Wash each indi- vidually by hand in warm water. Mild detergent may be used if desired. Rinse well, then air dry

thoroughly before putting them back together and replacing in filter cup.

5.The filter cup may be washed in warm water with a mild detergent. Make sure it is completely dry before reassembling with filters.

6.The upper tank and primary separator may be wiped clean with a damp cloth. Reach underneath the upper tank and turn the rim of the primary separator to unlock. Pull straight down to remove.

Cleaning the pre-motor filter

NOTICE:

This product is intended for household use only and not for commercial or industrial use. Vacuuming of dust from products like plaster, concrete or ashes will damage the motor and void the warranty.

1.Unplug the cleaner from electrical outlet.

2.The pre-motor filter protects the motor from debris. It is located underneath the dirt container and filter cup in the center of the round part of the Lock ‘n Seal lever.

3.Remove the small, round, pre-motor filter and any debris on top of it. Rinse well under warm water, then air dry thoroughly before replacing.

WARNING:

Do not operate cleaner with damp or wet filters or without all filters in place.

Pre-Motor

Filter

9

w w w . b i s s e l l . c o m

Page 8 Page 10
Image 9
Page 8 Page 10
Contents 80E7 and 28F4 Series CLEANviewThanks for buying a Bissell Cleanview Cyclonic Reduce the risk of fire, electric shock, or injury Important Safety InstructionsProduct view Assembly Attach handle to vacuumAttach vacuum hose and tools Transporting cleaner Powerfoot height adjustmentLowest Setting For bare floors OperationsTurn power switch OFF Power cordSpecial tools Raise handle to upright positionEmptying dirt container Maintenance and careFull Line UnlockCleaning the pre-motor filter Cleaning the inner & outer circular filtersUnplug cleaner from electrical outlet Pre-Motor FilterReplacing the Hepa media post-motor filter Maintaining the TurboBrush toolMedia Post-Motor Filter Unplug cleaner from electrical outlet Brush Check rotating floor brush and drive beltReplace drive belt Clearing clog Troubleshooting Replacement parts Part Name203-1068 Extension Wand 203-1216 Limited One Year Warranty WarrantyFor spare parts and accessories For UK inquiriesBissell consumer services If your Bissell product should require service
Top Page Image Contents