Euro-Pro EP923H Using Your Steam Cleaner with Steam Pocket, Attaching the Shoulder Strap

Fig. 23

OPERATING INSTRUCTIONS

OPERATING INSTRUCTIONS

Using Your Steam Cleaner with Steam Pocket

Step 1: Connect one of the extension tubes to the hand grip on the flexible steam hose. To attach the extension tubes one onto the other or onto the hand grip, press the locking button ensuring that it fits into the hole. (Fig. 2, Fig. 3) To disconnect, repeat the operation by pressing the locking button and pulling the two sections apart.

Fig. 2

Fig. 3

NOTE: Fit the steam pocket frame with the angle adapter onto the extension tube.

Step 2: If the angle adapter is not attached to the steam pocket frame, hold the steam pocket frame your left hand. With the angle adapter pointing downward, insert it into the hole of the steam pocket frame, then turn the steam pocket frame 180°.

Step 3: Insert the electrical power cord into the wall outlet. Heating time is approximately 8-10 minutes with cold water. Filling the steam generator with hot water will shorten the heat up time.

NOTE: Do not use the soap injector with the steam pocket attachment.

Attaching the Steam Pocket Towel to the Frame

WARNING: Always insure the unit is “UNPLUGGED” from the wall receptacle prior to attaching or removing accessories.

1.Slide the steam pocket towel over the steam pocket frame. (Fig. 4)

Fig. 4

2.Bring the towel all the way to the top of the steam pocket frame. (Fig. 5)

Fig. 5

3.Bring the velcro strips that are on the back side of the steam pocket towel over the steam pocket frame and attach to the inside of the front side of the steam pocket towel. (Fig. 6)

Fig. 6

Attaching the Shoulder Strap

Using the detachable shoulder strap allows for greater freedom of movement when both hands are needed for various cleaning tasks.

To attach the shoulder strap to the steam cleaner, simply snap the shoulder strap hooks onto the connecting

rings on the unit body.

See Fig. 23, 24 & 25.

Fig. 24

Fig. 25

IMPORTANT: When using the steam cleaner with the shoulder strap, avoid rocking or tilting the unit excessively as this may cause water to enter the hose and be discharged along with the steam.

Assembling the Caddy

The casters for the caddy for the steam cleaner are packed and shipped unassembled. To assemble the casters to the caddy, simply insert the caster stem into one of the four (4) holes in the base and push downward with the palm of your hand. (Fig. 26) Repeat for the next three (3) casters.

Fig. 26

Attaching the Steam Cleaner to the Caddy

1.After you have inserted the castors to the base of the caddy, turn the caddy right side up on a flat, level surface. Place it with the rear locking latch to your right.

2.Hold the steam cleaner with the power cord also to your right.

3.Insert the left side of the steam cleaner (#1 in the illustration below) down into the caddy making sure that it clips into the front locking tab.

4.Then press down on the right

side of the steam cleaner (#2 in the illustration below) so that the rear locking latch locks in place.

(Fig. 27)

Front

Locking

TabRear

Locking

Latch

Fig. 27

6

11