6.INSTALL AND FLUSH FILTER CARTRIDGE
Q.Lift handle of the
R.Hold Head firmly with one hand.
S.Align cartridge lug with label on filter Head.
T.Insert filter Cartridge – Push upwards.
U.Turn it to the right – About 1⁄4 turn – Until rotation stops.
V.Open Side Valve of Angle Stop Adaptor and check for leaks up to Inlet Elbow Fitting.
W.Open Filtered Water Faucet.
X.Lower the QC Valve Handle to flush water to the sink.
NOTE: Flush new filter cartridges for at least 3 minutes to remove air and any loose carbon. At first the water may appear cloudy due to trapped air in the filter and tubing. If water continues to be cloudy for more that one week, please contact Everpure Technical Services for assistance.
Y.Remove plastic wrapper and pull Tab from back of Everpure Filter Timer. The LED and buzzer will cycle 3 times to confirm the start. It is programmed to flash/ sound again in 11 months. Remove adhesive backing and mount Timer in a convenient location under the sink.
6 | Q |
|
|
| |
| S |
|
| Label |
|
| Lug |
|
| R | U |
| T | |
|
| |
V | W | X |
Y | www.everpure.com |
|
| WATER FILTER MONITOR |
|
ENGLISH
H-1200 Instructions
Tools Needed For Installation
•Phillips Screwdriver
•Wrench
•Utility Knife
•Measuring Tape
•Pencil
1.Open Carton & Inspect Parts Installation Parts
Key | Description | Part No. |
1 | QL Twin Series Filter Head | |
2 | Filter Cartridges (Set of 2) | |
3 | 2 Locking Washers | |
4 | 2 Screws | |
5 | Angle Stop Valve Adaptor | |
6 | Tubing, 1/4" poly | A0860119 |
7 | Elbow Fitting Pack Restrictor | |
8 | Teflon® Tape | |
9 | Faucet Connector | |
10 | Everpure Filter Timer | |
11 | Shut Off Valve, | |
| 3/8" John Guest x 3/8" FPT |
|
12 | Coupler, 3/8" FPT Stainless | |
|
|
|
1 |
| 3 | 4 |
|
|
|
1 |
|
| 5 |
| ||
|
|
|
|
|
| |
|
|
| 7 |
| 8 |
|
| 2 |
|
|
|
| |
| 6 |
|
|
|
| |
|
|
|
|
|
| |
|
|
| 10 |
| 11 |
|
|
|
| www.everpure.com | WATER FILTER MONITOR |
| |
|
|
|
|
| ||
|
| 9 |
|
| 12 |
|
|
|
|
|
|
| |
|
|
|
|
| • | • |